[U-Boot-Users] [PATCH] at91: Fix to enable using Teridian MII phy (78Q21x3) with at91sam9260

[Manuel Sahm]

Hello,

thanks a lot.

Could you please take care that this will be fixed in the kernel code, too ?

Best regards

Manuel Sahm


Anatolij Gustschin schrieb:
> Manuel Sahm wrote:
>
>   
>> if I apply the patch with:
>>
>> patch -p1 < patchat91.diff
>>
>> some messages occur, is this correct ?
>>
>>
>> (Stripping trailing CRs from patch.)
>> patching file board/atmel/at91sam9260ek/at91sam9260ek.c
>> patch unexpectedly ends in middle of line
>> Hunk #1 succeeded at 183 with fuzz 2 (offset -5 lines).
>>     
>
> it is very likely that these messages occur because the patch
> was incorrectly saved from the email body. This patch applies
> cleanly against top of our u-boot git tree.
>  
>   
>> The description is correct - PA23 and PA24 are connected to the TWI
>> EEPROM an the DevBoard at91sam9260ek.
>> The patch works well.
>> Here the signed-off line:
>>
>> Signed-off-by: Manuel Sahm <Manuel.Sahm at feig.de>
>>     
>
> Thanks, I will repost the patch again.
>
>   
>> Another problem is, that the same error is in the official kernel tree
>> in the file at91sam9260ek_devices.c ?!
>> Although the error is still in the kernel, a modification of the uboot
>> file at91sam9260ek.c is enough to get ethernet working ?
>>     
>
> if the kernel resets Peripheral B pin configuration, then
> ethernet will stop working, I think. This should be fixed in
> the kernel code, too.
>
> Best regards,
> Anatolij
>
>   
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.denx.de/pipermail/u-boot/attachments/20080710/cf222fee/attachment.htm