[U-Boot-Users] [PATCH 0/6] Update sbc8560; enable fdt/powerpc support

Paul Gortmaker paul.gortmaker at windriver.com
Fri Jul 11 21:33:02 CEST 2008


[Resending with Ben's network setting removal done in patch #3; there were
no other request for changes, so this should be good to go...]

The following six patches update the sbc8560 support to fix a memsize
bug + some bitrot (1st three), and then add/enable the powerpc/fdt support
(the second three).  One additional patch required for using the sbc8560
on 1.3.x; the setting of the UART clk in mpc85xx/fdt.c isn't included
here, as that wasn't a fix in a board specific file, and so it is being
reviewed/submitted separately.

Thanks,
Paul.


0001-sbc8560-proper-definitions-for-TSEC.patch
 b/include/configs/sbc8560.h |   32 ++++++++++++++++++++++----------

0002-sbc8560-properly-set-cs0_bnds-for-512MB.patch
 b/board/sbc8560/sbc8560.c |    4 ++++

0003-sbc8560-define-eth0-and-eth1-instead-of-eth1-and-eth2.patch
 b/include/configs/sbc8560.h |   22 +++++++++++++---------

0004-sbc8560-add-in-ft_board_setup.patch
 b/board/sbc8560/sbc8560.c |   28 ++++++++++++++++++++++++++++

0005-sbc8560-add-default-fdt-values.patch
 b/include/configs/sbc8560.h |   34 +++++++++++++++++++++++++++++++---

0006-sbc8560-enable-CONFIG_OF_LIBFDT-by-default.patch
 b/include/configs/sbc8560.h |    5 +++++






More information about the U-Boot mailing list