[U-Boot-Users] [PATCH] NAND FSL UPM: driver re-write using the hwcontrol callback

Anton Vorontsov avorontsov at ru.mvista.com
Mon Jun 2 13:42:14 CEST 2008


On Mon, Jun 02, 2008 at 12:11:11PM +0200, Wolfgang Grandegger wrote:
> NAND FSL UPM: driver re-write using the hwcontrol callback
> 
> This is a re-write of the NAND FSL UPM driver using the more universal
> hwcontrol callback (instead of the cmdfunc callback). Here is a brief
> list of furher modifications:
> 
> - For the time being, the UPM setup writing the UPM array has been
>   removed from the driver and must now be done by the board specific
>   code.
> 
> - The bus width definition in "struct fsl_upm_nand" is now in bits to
>   comply with the corresponding Linux driver.
> 
> - chip->dev_read is only set if fun->dev_ready != NULL, which is
>   required for boards not connecting the R/B pin.
> 
> - A few issue have been fixed with MxMR bit manipulation like in the
>   corresponding Linux driver.
> 
> Note: I think the "io_addr" field of "struct fsl_upm" could be removed
>       as well, because the address is already determined by
>       "nand->IO_ADDR_[RW]", but I'm not 100% sure.
> 
> This patch has been tested on a TQM8548 modules with the NAND chip
> Micron MT29F8G08FABWP.
> 
> This patch is based on the following patches posted to this list a few
> minutes ago:
> 
>   [PATCH] PPC: add accessor macros to clear and set bits in one shot
>   [PATCH] 83xx/85xx/86xx: add more MxMR local bus definitions
> 
> Anton, could you please verify if it works on your MPC8360ERDK board as
> well. A patch will follow. In principle, the NAND driver of the TQM8272
> should work with it as well.

Works great here (tested on MPC8360E-RDK). Thanks!

> Signed-off-by: Wolfgang Grandegger <wg at grandegger.com>

Acked-by: Anton Vorontsov <avorontsov at ru.mvista.com>




More information about the U-Boot mailing list