[U-Boot-Users] [PATCH v5] QE IO: Add initial data to pin configuration + read/write functions

[David Saada]

> David Saada wrote:
> > On the MPC83xx & MPC85xx architectures that have QE, add initial
data to
> the
> > pin configuration table (qe_iop_conf_tab). This is relevant for GPIO
> pins
> > defined as output. One can setup a value of -1 to leave the value
> unchanged.
> > QE initialization tables in all relevant boards were also replaced.
> > In addition, add IO pin read & write functions.
> > This patch also includes commands for reading and writing parallel
I/O
> ports
> > (pario command).
> >
> > Signed-off-by: David Saada <david.saada at ecitele.com>
> 
> Acked-by: Timur Tabi <timur at freescale.com>
> 
> FYI David, I just noticed this patch yesterday.  I would have noticed
it
> and
> ack'd it back on the 7th if you had included my email address on the
"To:"
> line.

Sorry about that. I had some problems with my mailer, so I decided to
post the patch using the Nabble forum. Problem here is that it doesn't
allow both posting on the list and CCing someone else.
David.