[U-Boot-Users] [MPC8555CDS] 1.3.2-rc3 -- TSECx: No link

[Marcel Moolenaar]

All,

I just upgraded U-Boot from 1.1.6 to 1.3.2-rc3 on a MPC8555CDS
and it seems TSEC isn't working. I see the same on another one,
but only after rebooting from FreeBSD. In that case a reset
from U-Boot resolves the problem. This board however always has
a link problem.

Is this a know issue?
Has this been fixed and I simply missed it?

Thanks,

\begin{log}
U-Boot 1.3.2-rc3 (Mar  7 2008 - 15:08:02)

CPU:   8555, Version: 1.1, (0x80790011)
Core:  E500, Version: 2.0, (0x80200020)
Clock Configuration:
        CPU: 825 MHz, CCB: 330 MHz,
        DDR: 165 MHz, LBC:  82 MHz
L1:    D-cache 32 kB enabled
        I-cache 32 kB enabled
Board: CDS Version 0x11, PCI Slot 1
CPU Board Revision 1.1 (0x0101)
     PCI1: 32 bit, 33 MHz, sync
     PCI2: 32 bit, 66 MHz, async
I2C:   ready
DRAM:  Initializing
        Reusing current 256MB configuration
     SDRAM: 64 MB
     DDR: 256 MB
FLASH: 16 MB
L2 cache 256KB: already enabled.
PCI-X will only work at 66 MHz
         01  02  1957  3fff  0604  00
         01  04  1106  0686  0601  00
         01  04  1106  0571  0101  0e
         01  04  1106  3038  0c03  00
         01  04  1106  3038  0c03  00
         01  04  1106  3057  0000  00
         01  04  1106  3058  0401  00
         01  04  1106  3068  0780  00
         01  05  10ec  8139  0200  00
         00  1c  1014  01a7  0604  ff
In:    serial
Out:   serial
Err:   serial
Net:   TSEC0, TSEC1
Hit any key to stop autoboot:  0
=> ping 192.168.1.1
TSEC0: No link.
TSEC1: No link.
ping failed; host 192.168.1.1 is not alive
\end{log}

-- 
Marcel Moolenaar
xcllnt at mac.com