[U-Boot-Users] [PATCH 8/8] SPARC: Added LEON2 and LEON3 boards and simulators

[Wolfgang Denk]

In message <47D8F681.4010306 at gaisler.com> you wrote:
> This patch adds support for three LEON3 boards:
>  * GR-XC3S-1500 (Low cost Xilinx Spartan FPGA board)
>  * GR-CPCI-AX2000 (AX system with switchable AX FPGA)
>  * ALTERA NIOS Development board, Stratix II edition
> 
> The simulators GRSIM and TSIM for LEON2 and LEON3 has
> been added as a board. A separate board is needed due to
> that the FLASH CFI interface has not been implemented
> in the simulators. Configuring the GR-XC3S-1500 board
> without FLASH support should run in the simulator.
> 
> Note that by board support I mean support for the
> pre synthezied template design for the board in
> question. Supporting any configuration is not possible
> but almost, due to the Plug & Play system...
> The FPGA can be programmed with the template design by:
>  $ cd grlib/designs/BOARD
>  $ make ise-prog-prom-ref
> 
> Best Regards,
> Daniel Hellstrom
> 
> 
>  MAKEALL                                       |    2 +-
>  Makefile                                      |   21 ++
>  board/gaisler/gr_cpci_ax2000/Makefile         |   52 ++++
>  board/gaisler/gr_cpci_ax2000/config.mk        |   37 +++
>  board/gaisler/gr_cpci_ax2000/gr_cpci_ax2000.c |   54 ++++
>  board/gaisler/gr_cpci_ax2000/u-boot.lds       |  160 ++++++++++
>  board/gaisler/gr_ep2s60/Makefile              |   52 ++++
>  board/gaisler/gr_ep2s60/config.mk             |   35 +++
>  board/gaisler/gr_ep2s60/gr_ep2s60.c           |   54 ++++
>  board/gaisler/gr_ep2s60/u-boot.lds            |  160 ++++++++++
>  board/gaisler/gr_xc3s_1500/Makefile           |   52 ++++
>  board/gaisler/gr_xc3s_1500/config.mk          |   34 ++
>  board/gaisler/gr_xc3s_1500/gr_xc3s_1500.c     |   54 ++++
>  board/gaisler/gr_xc3s_1500/u-boot.lds         |  162 ++++++++++
>  board/gaisler/grsim/Makefile                  |   50 +++
>  board/gaisler/grsim/config.mk                 |   34 ++
>  board/gaisler/grsim/grsim.c                   |   43 +++
>  board/gaisler/grsim/u-boot.lds                |  161 ++++++++++
>  board/gaisler/grsim_leon2/Makefile            |   50 +++
>  board/gaisler/grsim_leon2/config.mk           |   34 ++
>  board/gaisler/grsim_leon2/grsim_leon2.c       |   44 +++
>  board/gaisler/grsim_leon2/u-boot.lds          |  159 ++++++++++
>  include/configs/gr_cpci_ax2000.h              |  398 
> +++++++++++++++++++++++++
>  include/configs/gr_ep2s60.h                   |  348 +++++++++++++++++++++
>  include/configs/grsim.h                       |  388 
> ++++++++++++++++++++++++
>  include/configs/grsim_leon2.h                 |  378 
> +++++++++++++++++++++++
>  include/configs/grxc3s1500.h                  |  334 +++++++++++++++++++++
>  27 files changed, 3349 insertions(+), 1 deletions(-)
> 
> The patch is larger than 40Kb, you can find it at 
> ftp://ftp.gaisler.com/gaisler.com/u-boot/patches/8_sparc_boards.patch

Split this (one board per patch) and it will easily fit in the 100 kB
hard limit.

But please fix all the coding style issues before resubmitting.

Also make sure to clean up dead code - ther eshould be no "#if 0"
anywhere in your code.

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
I have never understood the female capacity to avoid a direct  answer
to any question.
	-- Spock, "This Side of Paradise", stardate 3417.3