[U-Boot] [PATCH] Remove gap fill in srec object v2

[Wolfgang Denk]

Dear Ricardo Ribalda Delgado,

In message <1220821827-6250-1-git-send-email-ricardo.ribalda at uam.es> you wrote:
> SREC files do not need gap fill: The load address is specified in the file.
> On the other hand, it can't be avoided in a .bin object. It has no
> information about memory location.
> 
> diff in v2:
> -Change comment (wd)
> 
> Signed-off-by: Ricardo Ribalda Delgado <ricardo.ribalda at uam.es>
> ---
>  Makefile |    2 +-
>  1 files changed, 1 insertions(+), 1 deletions(-)

Applied, thanks.

Note: the comment ("diff in v2: ...") should have been put *below* the
'---' line.

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
"Logic and practical information do not seem to apply here."
"You admit that?"
"To deny the facts would be illogical, Doctor"
	-- Spock and McCoy, "A Piece of the Action", stardate unknown