[U-Boot] ctrl-c detection (on 4xx platforms)

[Wolfgang Denk]

Dear Matthias Fuchs,

In message <200809111723.54133.matthias.fuchs at esd-electronics.com> you wrote:
> 
> I noticed some strange CTRL-C behavior in a BSP command. 
> When I run my bsp command interactively everything is fine.
...
> But when I call this bsp command as bootcmd CTRL-C does not stop the while loop. So CTRL-C 
> is not detected. Any idea?

Do you happen to have CONFIG_AUTOBOOT_KEYED set in your board
configuration?

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Program maintenance is an entropy-increasing process,  and  even  its
most skilfull execution only delays the subsidence of the system into
unfixable obsolescence.       - Fred Brooks, "The Mythical Man Month"