[U-Boot] U-boot initialization test

[eija_flight]

Hello,

Below is my board initialization process :

U-Boot 1.3.1 (Nov 27 2008 - 08:30:43) MPC83XX

Reset Status: Software Hard, External/Internal Soft, External/Internal Hard

CPU:   e300c1, MPC8349E, Rev: 31 at 528 MHz, CSB:  264 MHz
Board: MPX8349GC
PCI1:  32 bit, 33 MHz
SRAM:   1 MB
I2C:   ready
DRAM:  512 MB (DDR2, 64-bit, ECC on)
FLASH: 16 MB
PCI:   Bus Dev VenId DevId Class Int
        00  0f  10cf  202b  0380  00
In:    serial
Out:   serial
Err:   serial
Net:   TSEC0, TSEC1

During above initialization process of u-boot, 

1. Does it conduct a test to all board hardware listed?
2. If above answer is yes, what method is used to do the test? 
-- 
View this message in context: http://www.nabble.com/U-boot-initialization-test-tp22840615p22840615.html
Sent from the Uboot - Users mailing list archive at Nabble.com.