[U-Boot] Booting uImage on the mx31

[alfred steele]

Hi,

I am using an uImage generated by LTIB .  I am not sure how the ideal
uImage is generated for the PDK board.
I try booting this uimage from RAM and then load it at 80008000.

It gets stuck after "done, booting the kernel." Please see the bootup
messages below.

Any hints?  I hope with, 0x80008000 as the load address on the MX31,
you eliminate the cause of one probable failure, overlay memory  with
the existing code on RAM e.g. existing u-boot and the compressed
kernel image

mc911x: MAC 92:92:92:bb:bb:bb
TFTP from server 206.44.18.25; our IP address is 206.44.18.31
Filename 'uImage_spin2'.
Load address: 0x80800000
Loading: #################################################################
        #################################################
done
Bytes transferred = 1665060 (196824 hex)
## Booting kernel from Legacy Image at 80800000 ...
  Image Name:   Linux-2.6.24-140-g68eb4b4
  Created:      2009-04-23   3:28:44 UTC
  Image Type:   ARM Linux Kernel Image (uncompressed)
  Data Size:    1664996 Bytes =  1.6 MB
  Load Address: 80008000
  Entry Point:  80008000
  Verifying Checksum ... OK
  Loading Kernel Image ... OK
OK

Starting kernel ...

Uncompressing Linux.............................................................
............................................... done, booting the kernel.

<IT freezes here>


Thanks,
Alfred.