[U-Boot] [PATCH 2/2] Support for the Calao TNY-A9260/TNY-A9G20 boards

[Wolfgang Denk]

Dear Albin Tonnerre,

In message <1249641457-16887-2-git-send-email-albin.tonnerre at free-electrons.com> you wrote:
> The Calao TNY-A9260 and TNY-9G20 are boards manufactured and sold by
> Calao Systems <http://www.calao-systems.com>. Their components are very
> similar to the AT91SAM9260EK board, so their configuration is based on
> the configuration of this board. There are however some differences:
> different clocks, no LCD, no ethernet. They also can use SPI EEPROM to
> store the environment.
...
> --- a/Makefile
> +++ b/Makefile
> @@ -2838,6 +2838,25 @@ at91sam9g45ekes_config	:	unconfig
>  pm9263_config	:	unconfig
>  	@$(MKCONFIG) $(@:_config=) arm arm926ejs pm9263 ronetix at91
>  
> +tny_a9g20_nandflash_config \
> +tny_a9g20_eeprom_config \
> +tny_a9g20_config \
> +tny_a9260_nandflash_config \
> +tny_a9260_eeprom_config \
> +tny_a9260_config	:	unconfig
> +	@mkdir -p $(obj)include
> +	@if [ "$(findstring _nandflash,$@)" ] ; then \
> +		echo "#define CONFIG_ENV_IS_IN_NAND"	>>$(obj)include/config.h ; \
> +	else \
> +		echo "#define CONFIG_ENV_IS_IN_EEPROM"	>>$(obj)include/config.h ; \
> +	fi;
> +	@if [ "$(findstring _a9g20,$@)" ] ; then \
> +		echo "#define CONFIG_TNY_A9G20"	>>$(obj)include/config.h ; \
> +	else \
> +		echo "#define CONFIG_TNY_A9260"	>>$(obj)include/config.h ; \
> +	fi;
> +	@$(MKCONFIG) -a tny_a9260 arm arm926ejs tny_a9260 calao at91

Please do not add such scripting to the top level Makefile. Perform it
in your board config file instead.

For an example, please see 
http://thread.gmane.org/gmane.comp.boot-loaders.u-boot/65499


Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
A father doesn't destroy his children.
	-- Lt. Carolyn Palamas, "Who Mourns for Adonais?",
	   stardate 3468.1.