[U-Boot] ERROR: too many flash sectors

[SlinceArm]

Hi , everyone .

My u-boot version is 2009-01 and i try porting u-boot on pxa270 development
board.
when i power on my board then minicom show these information 

 DRAM:  64 MB
 ERROR: too many flash sectors
 ERROR: too many flash sectors
 Flash:    32 MB

then i can save setenv , but when i earse my flash ,it cause one error

 Error: end address not on sector boundary

and here is my flinfo : 

Bank # 1: CFI conformant FLASH (32 x 16)  Size: 32 MB in 128 Sectors
  Intel Extended command set, Manufacturer ID: 0x89, Device ID: 0x18
  Erase timeout: 4096 ms, write timeout: 1 ms
  Buffer write timeout: 2 ms, buffer size: 64 bytes

  Sector Start Addresses:
  00000000   RO   00040000   RO   00080000   RO   000C0000   RO   00100000  
RO
  etc...


And i dont know my network chip work or not . ( my chip is LAN91C113 )
when i ping some address , it show 
 
 ethid=0000...
 LAN91C113:PHY auto-negotiate timed out

then my bootloader freeze ....

would someone can help me ? thanks.

 


-- 
View this message in context: http://www.nabble.com/-U-Boot--ERROR%3A-too-many-flash-sectors-tp25063511p25063511.html
Sent from the Uboot - Users mailing list archive at Nabble.com.