[U-Boot] [PATCH 5/9] SPEAr600 SoC support added

[Vipin Kumar]

Dear Wolfgang,

> In message <1261090481.11634.5308.camel at localhost.localdomain> you wrote:
>>
>> > > I haven't looked at the code differences between the sp3xx boards, but
>> > > you might be able to use 1 common board file/header file to support them
>> > > all.  For example, take a look at the M5475AFE_config rule in
>> > > U-Boot's ./Makefile.  Some extra code in the Makefile and some #ifdefs
>> > > in the sp3xx code might accommodate all 3 boards.
>> >
>> > Extra code in the Makefile should not be needed any more.
>>
>> To be clear, you still think its a good idea to look into combining the
>> similar boards, correct?  I haven't dealt with the MKCONFIG voodoo, so
>
> Yes, of course.
>
>> maybe I chose a poor example.  Perhaps the CPCI405 and friends is a
>> better example?
>
> Or this:
>
> 2485 P1011RDB_config \
> 2486 P1011RDB_NAND_config \
> 2487 P1011RDB_SDCARD_config \
> 2488 P1011RDB_SPIFLASH_config \
> 2489 P1020RDB_config \
> 2490 P1020RDB_NAND_config \
> 2491 P1020RDB_SDCARD_config \
> 2492 P1020RDB_SPIFLASH_config \
> 2493 P2010RDB_config \
> 2494 P2010RDB_NAND_config \
> 2495 P2010RDB_SDCARD_config \
> 2496 P2010RDB_SPIFLASH_config \
> 2497 P2020RDB_config \
> 2498 P2020RDB_NAND_config \
> 2499 P2020RDB_SDCARD_config \
> 2500 P2020RDB_SPIFLASH_config:       unconfig
> 2501         @$(MKCONFIG) -t $(@:_config=) P1_P2_RDB ppc mpc85xx p1_p2_rdb freescale
>
>
> No scripting any more in the Makefile :-)

Ok. Used the above example to combine SPEAr boards

Best Regards
Vipin