[U-Boot] [PATCH 1/1] Setup extra MIMC200 chip selects

[Wolfgang Denk]

Dear Mark Jackson,

In message <492A8D60.3090309 at mimc.co.uk> you wrote:
> Added code to setup the extra Flash and FRAM chip selects
> as used on the MIMC200 board.
> 
> Signed-off-by: Mark Jackson <mpfj at mimc.co.uk>
> 
> ---
>  cpu/at32ap/cpu.c |   14 ++++++++++++++
>  1 files changed, 14 insertions(+), 0 deletions(-)
> 
> diff --git a/cpu/at32ap/cpu.c b/cpu/at32ap/cpu.c
> index 1a13702..3902efe 100644
> --- a/cpu/at32ap/cpu.c
> +++ b/cpu/at32ap/cpu.c
> @@ -56,6 +56,20 @@ int cpu_init(void)
>  	hsmc3_writel(PULSE0, 0x0b0a0906);
>  	hsmc3_writel(SETUP0, 0x00010002);
>  
> +#ifdef CONFIG_MIMC200
> +	/* setup Data Flash chip select (NCS2) */
> +	hsmc3_writel(MODE2, 0x20121003);
> +	hsmc3_writel(CYCLE2, 0x000a0009);
> +	hsmc3_writel(PULSE2, 0x0a060806);
> +	hsmc3_writel(SETUP2, 0x00030102);
> +
> +	/* setup FRAM chip select (NCS3) */
> +	hsmc3_writel(MODE3, 0x10120001);
> +	hsmc3_writel(CYCLE3, 0x001e001d);
> +	hsmc3_writel(PULSE3, 0x08040704);
> +	hsmc3_writel(SETUP3, 0x02050204);
> +#endif

I feel it is conceptually wrong to add board specific code to a common
CPU specific file.

Haavard, please comment?

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Accident: A condition in which presence of mind is good, but  absence
of body is better.