[U-Boot] [PATCH 13/31] powerpc: mgcoge, mgsuvd: move IVM feature config to keymile-common.h

[Heiko Schocher]

the IVM feature is enabled for all keymile boards
therefore the configuration parameters are trans-
ferred from the board specific config files to
keymile-common.h.

Signed-off-by: Thomas Herzmann <thomas.herzmann at keymile.com>
Signed-off-by: Heiko Schocher <hs at denx.de>
---
 include/configs/keymile-common.h |   20 ++++++++++++++++++++
 include/configs/mgcoge.h         |   19 +------------------
 include/configs/mgsuvd.h         |   19 +------------------
 3 files changed, 22 insertions(+), 36 deletions(-)

diff --git a/include/configs/keymile-common.h b/include/configs/keymile-common.h
index aaefdf1..2e324fe 100644
--- a/include/configs/keymile-common.h
+++ b/include/configs/keymile-common.h
@@ -106,6 +106,26 @@
 #define CONFIG_SYS_SLOT_ID_OFF		(0x07)	/* register offset */
 #define CONFIG_SYS_SLOT_ID_MASK		(0x3f)	/* mask for slot ID bits */

+#if defined(CONFIG_MGCOGE) || defined(CONFIG_MGSUVD)
+#define CONFIG_I2C_MULTI_BUS	1
+#define CONFIG_I2C_CMD_TREE	1
+#define CONFIG_SYS_MAX_I2C_BUS		2
+#define CONFIG_SYS_I2C_INIT_BOARD	1
+#define CONFIG_I2C_MUX		1
+
+/* EEprom support */
+#define CONFIG_SYS_I2C_EEPROM_ADDR_LEN	1
+#define CONFIG_SYS_I2C_MULTI_EEPROMS	1
+#define CONFIG_SYS_EEPROM_PAGE_WRITE_ENABLE
+#define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3
+#define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 10
+
+/* Support the IVM EEprom */
+#define	CONFIG_SYS_IVM_EEPROM_ADR	0x50
+#define CONFIG_SYS_IVM_EEPROM_MAX_LEN	0x400
+#define CONFIG_SYS_IVM_EEPROM_PAGE_LEN	0x100
+#endif
+
 #define	CONFIG_SYS_FLASH_PROTECTION 1

 /*
diff --git a/include/configs/mgcoge.h b/include/configs/mgcoge.h
index f307382..070fe53 100644
--- a/include/configs/mgcoge.h
+++ b/include/configs/mgcoge.h
@@ -95,6 +95,7 @@
 		"10m(rootfs1),1m(var),5m(cfg) \0"			\
 	"partition=nor1,5 \0"						\
 	"new_env=prot off FE060000 FE09FFFF; era FE060000 FE09FFFF \0" 	\
+	"EEprom_ivm=pca9544a:70:4 \0"					\
 	""

 #define CONFIG_SYS_SDRAM_BASE		0x00000000
@@ -150,24 +151,6 @@
 			else    iop->pdat &= ~0x00020000
 #define I2C_DELAY	udelay(5)	/* 1/4 I2C clock duration */

-#define CONFIG_I2C_MULTI_BUS	1
-#define CONFIG_I2C_CMD_TREE	1
-#define CONFIG_SYS_MAX_I2C_BUS		2
-#define CONFIG_SYS_I2C_INIT_BOARD	1
-#define CONFIG_I2C_MUX		1
-
-/* EEprom support */
-#define CONFIG_SYS_I2C_EEPROM_ADDR_LEN	1
-#define CONFIG_SYS_I2C_MULTI_EEPROMS	1
-#define CONFIG_SYS_EEPROM_PAGE_WRITE_ENABLE
-#define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3
-#define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 10
-
-/* Support the IVM EEprom */
-#define	CONFIG_SYS_IVM_EEPROM_ADR	0x50
-#define CONFIG_SYS_IVM_EEPROM_MAX_LEN	0x400
-#define CONFIG_SYS_IVM_EEPROM_PAGE_LEN	0x100
-
 /* I2C SYSMON (LM75, AD7414 is almost compatible)			*/
 #define CONFIG_DTT_LM75		1	/* ON Semi's LM75		*/
 #define CONFIG_DTT_SENSORS	{0}	/* Sensor addresses		*/
diff --git a/include/configs/mgsuvd.h b/include/configs/mgsuvd.h
index 7c97a21..700878f 100644
--- a/include/configs/mgsuvd.h
+++ b/include/configs/mgsuvd.h
@@ -69,6 +69,7 @@
 		"2432k(rootfs1),640k(var),768k(cfg)\0"			\
 	"partition=nor0,9 \0"						\
 	"new_env=prot off F0060000 F009FFFF; era F0060000 F009FFFF \0" 	\
+	"EEprom_ivm=pca9544a:70:4 \0"					\
 	""

 #undef CONFIG_RTC_MPC8xx		/* MPC866 does not support RTC	*/
@@ -290,24 +291,6 @@
 			}
 #define I2C_DELAY	udelay(50)	/* 1/4 I2C clock duration */

-#define CONFIG_I2C_MULTI_BUS	1
-#define CONFIG_I2C_CMD_TREE	1
-#define CONFIG_SYS_MAX_I2C_BUS		2
-#define CONFIG_SYS_I2C_INIT_BOARD	1
-#define CONFIG_I2C_MUX		1
-
-/* EEprom support */
-#define CONFIG_SYS_I2C_EEPROM_ADDR_LEN	1
-#define CONFIG_SYS_I2C_MULTI_EEPROMS	1
-#define CONFIG_SYS_EEPROM_PAGE_WRITE_ENABLE
-#define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3
-#define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 10
-
-/* Support the IVM EEprom */
-#define	CONFIG_SYS_IVM_EEPROM_ADR	0x50
-#define CONFIG_SYS_IVM_EEPROM_MAX_LEN	0x400
-#define CONFIG_SYS_IVM_EEPROM_PAGE_LEN	0x100
-
 /* I2C SYSMON (LM75, AD7414 is almost compatible)			*/
 #define CONFIG_DTT_LM75		1	/* ON Semi's LM75		*/
 #define CONFIG_DTT_SENSORS	{0, 2, 4, 6}	/* Sensor addresses		*/
-- 
1.6.0.6

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany