[U-Boot] [PATCH2/2] Sheevaplug: Add Kirkwood gpio support to Sheevaplug
Prafulla Wadaskar
prafulla at marvell.com
Thu Jul 9 10:12:00 CEST 2009
> -----Original Message-----
> From: Dieter Kiermaier [mailto:dk-arm-linux at gmx.de]
> Sent: Thursday, July 09, 2009 12:50 PM
> To: Prafulla Wadaskar
> Subject: Re: [U-Boot] [PATCH2/2] Sheevaplug: Add Kirkwood
> gpio support to Sheevaplug
>
> Hi Prafulla,
>
> >
> > > -----Original Message-----
> > > From: Dieter Kiermaier [mailto:dk-arm-linux at gmx.de]
> > > Sent: Thursday, July 09, 2009 12:25 PM
> > > To: Jean-Christophe PLAGNIOL-VILLARD
> > > Cc: u-boot at lists.denx.de; Prafulla Wadaskar
> > > Subject: Re: [U-Boot] [PATCH2/2] Sheevaplug: Add Kirkwood gpio
> > > support to Sheevaplug
> > >
> > > Hi Jean, hi Prafulla,
> > >
> > > here the corrected version.
> > >
> > > Many thanks,
> > > Dieter
> > >
> > > > On 14:45 Mon 29 Jun , Dieter Kiermaier wrote:
> > > > > Hi,
> > > > >
> > > > > patch 2 of 2 which adds Kirkwood GPIO support to Sheevaplug.
> > > > > Any comments are welcome!
> > Hi Dieter
> > Thanks for your efforts
> > That's good, gpio driver is supported for Kirkwood but,
> Again question
> > remains the same- Why do you need gpio support on
> Sheevaplug? Whereas you have no evidence to use it.
>
> That's a good question :)
> I need gpio support for my own board which will come up the
> next 2 months.
> So maybe you're right. There is no need for GPIO support on
> SheevaPlug.
Well.. you better post separate patch for your board that needs to use gpio support.
> On the other hand there are maybe some hackers out there
> using sheevaplug not only as it is. So maybe there is a need
> for some GPIO bitbanging?
> At least if you open the case :)
I will post this information on plug forum (http://plugcomputer.org/plugforum/index.php).
Also a small how-to doc to uses gpio support for bit bang interface.
>
> Also many thanks to all of you out there for such a nice boot
> loader :) Dieter
Thanks to yourself too :-) let's make it further better.
Regards.
Prafulla . .
More information about the U-Boot
mailing list