[U-Boot] [PATCH 0/4] OMAP3 pandora: pin mux updates

Grazvydas Ignotas notasas at gmail.com
Thu Jul 9 14:20:55 CEST 2009


On Thu, Jul 9, 2009 at 1:44 AM, Jean-Christophe
PLAGNIOL-VILLARD<plagnioj at jcrosoft.com> wrote:
> On 00:29 Wed 08 Jul     , Grazvydas Ignotas wrote:
>> This patch series clean up and update pin mux for pandora.
>> The update is needed for rev3 or later boards to work properly,
>> but older boards still work after this.
>>
>> Grazvydas Ignotas (4):
>>   OMAP3 pandora: pin mux cleanup
>>   OMAP3 pandora: setup pin mux for pins used on rev3 boards
>>   OMAP3 pandora: setup pulls for various GPIOs
>>   OMAP3 pandora: Fix CKE1 MUX setting to allow self-refresh
>>
>>  board/omap3/pandora/pandora.h |   86 +++++++++++++++++------------------------
>>  1 files changed, 35 insertions(+), 51 deletions(-)
>>
> what is the status of the precedent rev at the end of the patch series?

Works fine except one analog controller, but I have the only rev2
board with them and don't mind about that. All other boards with
analog controllers are rev3 and need these patches to work.


More information about the U-Boot mailing list