[U-Boot] [PATCH] Add inverted clock polarity support for Atmel LCD driver

[Anatolij Gustschin]

Jean-Christophe PLAGNIOL-VILLARD wrote:
> On 18:56 Wed 15 Jul     , Dimitar Dimitrov wrote:
...
>> --- a/drivers/video/atmel_lcdfb.c
>> +++ b/drivers/video/atmel_lcdfb.c
>> @@ -112,6 +112,9 @@ void lcd_ctrl_init(void *lcdbase)
>>  
>>  	value |= panel_info.vl_sync;
>>  	value |= (panel_info.vl_bpix << 5);
>> +#if defined(CONFIG_LCD_INVERTED_CLOCK)
>> +	value |= ATMEL_LCDC_INVCLK_INVERTED;
>> +#endif
> NACK
> 	do this throught the struct via vl_sync as in linux

actually the "vl_sync" is supposed to contain HSYNC and VSYNC
polarity flags and not the dot clock polarity. The Linux driver in
mainline uses var.sync for this purpose too, and doesn't set
inverted dot clock polarity at all.
This definition in struct vidinfo for Atmel LCD
	/* LCD configuration register */
        u_long vl_sync;         /* Horizontal / vertical sync */
        u_long vl_bpix;         /* Bits per pixel, 0 = 1, 1 = 2, 2 = 4, 3 = 8,
				 4 = 16 */
        u_long vl_tft;          /* 0 = passive, 1 = TFT */

is confusing. If these fields are supposed to contain flags
for LCD configuration register LCDCON2 then we should define
only one "u_long lcdcon2" field containing all the flags/fields
for sync polarity, bpp, clock polarity, scan mode, display type,
interface width, LCDD, LCDDEN polarities, LCDDOTCLK mode and memory
ordering format. We are wasting tree u_longs here and are not even
able to use half of the possible settings for LCDCON2 register.
I would rather fix the struct vidinfo for Atmel LCD so that
people could set needed flags in the board code, e.g.:

vidinfo_t panel_info = {
	...
	lcdcon2:	ATMEL_LCDC_INVLINE_INVERTED |
                        ATMEL_LCDC_INVFRAME_INVERTED |
			ATMEL_LCDC_INVCLK_INVERTED;
	...
}

I don't have the Atmel hardware to test/fix this change however.

Best regards,
Anatolij