[U-Boot] [PATCH-ARM 4/4, v3] Clean-up of s3c24x0 nand driver]

[Minkyu Kang]

Dear kevin.morfitt

2009/10/10 kevin.morfitt at fearnside-systems.co.uk
<kevin.morfitt at fearnside-systems.co.uk>:
> This patch re-formats the arm920t s3c24x0 nand driver in preparation for changes
> to add support for the Embest SBC2440-II Board.
>
> The changes are as follows:
> - re-indent the code using Lindent
> - make sure register layouts are defined using a C struct
> - replace the upper-case typedef'ed C struct names with lower case
> non-typedef'ed ones
> - make sure registers are accessed using the proper accessor functions
> - run checkpatch.pl and fix any error reports
>
> It assumes the following patch has been applied first:
> - [U-Boot][PATCH-ARM] CONFIG_SYS_HZ fix for ARM902T S3C24X0 Boards, 05/09/2009
>  - patches 1/4, 2/4 and 3/4 of this series
>
> Tested on an Embest SBC2440-II Board with local u-boot patches as I don't have
> any s3c2400 or s3c2410 boards but need this patch applying before I can submit
> patches for the SBC2440-II Board. Also, temporarily modified sbc2410x, smdk2400,
> smdk2410 and trab configs to use the mtd nand driver (which isn't used by any
> board at the moment), ran MAKEALL for all ARM9 targets and no new warnings or
> errors were found.
>
> Signed-off-by: Kevin Morfitt <kevin.morfitt at fearnside-systems.co.uk>
> ---
>
> Changes in v2: re-formatted patch to remove line wrapping
> Changes in v3: removed checkpatch.pl errors
>               moved change log
>
>  drivers/mtd/nand/s3c2410_nand.c |   62 +++++++++++++++-----------------------
>  1 files changed, 25 insertions(+), 37 deletions(-)
>

applied to u-boot-samsung

Thanks
Minkyu Kang
-- 
from. prom.
www.promsoft.net