[U-Boot] [PATCH 2/2] Fix compile errors for atmel_nand with hw-ecc and new SoC access

[Alexander Holler]

atmel_nand.c with HW-ECC doesn't compile with the new SoC access.
Using CONFIG_AT91_LEGACY to circumvent the compile errors only leaves
the driver in a state where it doesn't find the NAND.

To use HW-ECC with atmel_nand one has to use
CONFIG_SYS_NAND_ECC_BASE AT91_ECC0_BASE (instead of AT91_ECC0)
for an AT91SAM9263 or AT91_ECC_BASE for an AT91SAM9260.

I've removed three unused variables too.

Signed-off-by: Alexander Holler <holler at ahsoftware.de>
---
 drivers/mtd/nand/atmel_nand.c |    7 +++----
 1 files changed, 3 insertions(+), 4 deletions(-)

diff --git a/drivers/mtd/nand/atmel_nand.c b/drivers/mtd/nand/atmel_nand.c
index d5eb54a..5f10a02 100644
--- a/drivers/mtd/nand/atmel_nand.c
+++ b/drivers/mtd/nand/atmel_nand.c
@@ -35,9 +35,9 @@
 
 /* Register access macros */
 #define ecc_readl(add, reg)				\
-	readl(AT91_BASE_SYS + add + ATMEL_ECC_##reg)
+	readl(add + ATMEL_ECC_##reg)
 #define ecc_writel(add, reg, value)			\
-	writel((value), AT91_BASE_SYS + add + ATMEL_ECC_##reg)
+	writel((value), add + ATMEL_ECC_##reg)
 
 #include "atmel_nand_ecc.h"	/* Hardware ECC registers */
 
@@ -79,7 +79,6 @@ static struct nand_ecclayout atmel_oobinfo_small = {
 static int atmel_nand_calculate(struct mtd_info *mtd,
 		const u_char *dat, unsigned char *ecc_code)
 {
-	struct nand_chip *nand_chip = mtd->priv;
 	unsigned int ecc_value;
 
 	/* get the first 2 ECC bytes */
@@ -167,7 +166,7 @@ static int atmel_nand_correct(struct mtd_info *mtd, u_char *dat,
 		u_char *read_ecc, u_char *isnull)
 {
 	struct nand_chip *nand_chip = mtd->priv;
-	unsigned int ecc_status, ecc_parity, ecc_mode;
+	unsigned int ecc_status;
 	unsigned int ecc_word, ecc_bit;
 
 	/* get the status from the Status Register */
-- 
1.6.2.5