[U-Boot] support for spansion s29gl-p flash?

[Stefan Roese]

Hi Txema,

On Friday 23 April 2010 10:36:24 txema lopez wrote:
> > IIRC, then you problem was more related to using an 8bit wide chip (chip-
> > width) on an 16bit port-width,
> 
> Yes, it is our board flash layout.

OK. So you are using 2 chips interleaved on this 16bit bus (one on lower 8bits 
and one on higher 8bits), right?
 
> > than being a specific Numonyx issue. Correct?
> 
> But the same board with a Spansion S29GL flash is fully supported by
> U-Boot, so, I think It is a Numonyx issue.

I see. Did you check the Linux MTD drivers, if there is a Numonyx special 
handling here?

Thanks.

Cheers,
Stefan

--
DENX Software Engineering GmbH,      MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich,  Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-0 Fax: (+49)-8142-66989-80 Email: office at denx.de