[U-Boot] [PATCH] MX5: Add initial support for mx53

[Stefano Babic]

On 12/07/2010 03:58 AM, Jason Liu wrote:

>> I know all this crap is for MX51 in the TO1 version, even if I do not
>> know if there are boards with this first version of the processor.
>> Probably we must maintain this stuff for compatibility. Really I would
>> like to remove it completely ;-).
> 
> Do you mind that I remove it completely here?

Really I do not know. This is clearly a workaround for the first MX.51
version (TO1), and it makes no sense for actual processor's revision. I
do not know if there are mx51evk with this revision on board, but if
there are we should maintain this code for compatibility reason.

> The motivation to use " is_soc_type(CPU_TYPE) "is to remove the some
> #ifdef CONFIG_MX51in this file,
>  I can change back to the following,
> 
> + #if defined (MX_CPU_MX51)
> +               if (is_soc_rev(CHIP_REV_2_0) < 0) {
> +                                code snip
> +  }
> + #endif
> 
> Is this ok?

I think so. If we were able to do everything on runtime, then we could
proceed removing all #ifdef stuff. However, we need the #ifdef in the
header files to select the different internal structures between MX.51
and MX.53.

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================