[U-Boot] [PATCH 3/3] fsl_esdhc: Fix the voltage validation process

[Stefano Babic]

On 12/15/2010 09:20 AM, Kumar Gala wrote:
> From: Li Yang <leoli at freescale.com>
> 
> The current code use all the voltage range support by the host
> controller to do the validation.  This will cause problem when
> the host supports Low Voltage Range.  Change the validation
> voltage to be based on board setup.
> 
> Signed-off-by: Li Yang <leoli at freescale.com>
> ---

Tested-by: Stefano Babic <sbabic at denx.de>

Regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================