[U-Boot] [PATCH v2 1/3] MX5: Add initial support for MX53 processor

[Jason Liu]

Hi, Stefano,

2010/12/27 Stefano Babic <sbabic at denx.de>:
> On 12/22/2010 02:23 PM, Jason Liu wrote:
>> Add initial support for Freescale MX53 processor,
>>
>> - Add the iomux support and the pin definition,
>> - Add the regs definition, clean up some unused def from mx51,
>> - Add the low level init support, make use the freq input of setup_pll macro
>>
>> ---
>> Changes for v2:
>> -address some comments of Stefano Babic, remove the is_soc_type
>>  and use #ifdef,
>> -address the comments of stefano, remove CPU_TYPE def, remove something
>>  like /*0x760*/ comments in mx5x_pins.h.
>> -fix the build break for vision2 board
>
> A general remark. You posted two different patchset now to support the
> MX53 processor. As the patches are related, please combine all patches
> in a single patchset to avoid that only a few of them go to be applied
> and to simplify review.

The patch for support mx53 processor is tracked by version. Sorry, I don't catch
your mean. Thanks in advance for telling me clear on that if something wrong.

>
> Best regards,
> Stefano Babic
>
> --
> =====================================================================
> DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
> HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
> Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
> =====================================================================
> _______________________________________________
> U-Boot mailing list
> U-Boot at lists.denx.de
> http://lists.denx.de/mailman/listinfo/u-boot
>