[U-Boot] [PATCH V7 3/3] Add support for the LaCie ED Mini V2 board

[Prafulla Wadaskar]

> -----Original Message-----
> From: u-boot-bounces at lists.denx.de 
> [mailto:u-boot-bounces at lists.denx.de] On Behalf Of Albert Aribaud
> Sent: Thursday, June 10, 2010 2:20 AM
> To: u-boot at lists.denx.de
> Subject: [U-Boot] [PATCH V7 3/3] Add support for the LaCie ED 
> Mini V2 board
> 
> This patch adds support for the LaCie ED Mini V2 product
> which is based on the Marvell Orion5x SoC.
> 
> Signed-off-by: Albert Aribaud <albert.aribaud at free.fr>
> ---
>  MAINTAINERS                     |    4 +
>  MAKEALL                         |    1 +
>  Makefile                        |    3 +
>  board/LaCie/edminiv2/Makefile   |   53 ++++++++++++
>  board/LaCie/edminiv2/config.mk  |   27 ++++++
>  board/LaCie/edminiv2/edminiv2.c |   92 +++++++++++++++++++++
>  include/configs/edminiv2.h      |  172 
...snip...
> +/*
> + * Board-specific values for Orion5x MPP low level init:
> + * - MPPs 12 to 15 are SATA LEDs (mode 5)
> + * - Others are GPIO/unused (mode 3 for MPP0, mode 5 for
> + *   MPP16 to MPP19, mode 0 for others
> + */
> +
> +#define ORION5X_MPP0_7		0x00000003
> +#define ORION5X_MPP8_15		0x55550000
> +#define ORION5X_MPP16_23	0x00000000
> +
> +/*
> + * Board-specific values for Orion5x GPIO low level init:
> + * - GPIO3 is input (RTC interrupt)
> + * - GPIO16 is Power LED control (0 = on, 1 = off)
> + * - GPIO17 is Power LED source select (0 = CPLD, 1 = GPIO16)
> + * - GPIO18 is Power Button status (0 = Released, 1 = Pressed)
> + * - Last GPIO is 26, further bits are supposed to be 0.
> + * Enable mask has ones for INPUT, 0 for OUTPUT.
> + * Default is LED ON.
> + */
> +
> +#define ORION5X_GPIO_OUT_ENABLE	0x03fcffff
> +#define ORION5X_GPIO_OUT_VALUE	0x03fcffff

Ack for the patch, except above definition to be used in patch 1/3
Regards..
Prafulla . .