[U-Boot] TOT u-boot makes P1020RDB unbootable

[Felix Radensky]

Hi,

I've tried to flash TOT u-boot complied with ELDK 4.2 for P1020_config into
my P1020RDB RevD and bricked it. The same u-boot boots fine on P2020RDB 
revC.

I don't have BDI3000 at the moment to debug the problem. It would be 
great to fix it
before the release.

Below is u-boot output from P1020RDB running with u-boot-2009.11 from 
FSL BSP

U-Boot 2009.11-00001-g4458602-dirty (Feb 27 2010 - 11:13:42)

CPU0:  P1020E, Version: 1.0, (0x80ec0010)
Core:  E500, Version: 5.0, (0x80212050)
Clock Configuration:
       CPU0:800  MHz, CPU1:800  MHz,
       CCB:400  MHz,
       DDR:333.333 MHz (666.667 MT/s data rate) (Asynchronous), LBC:25   MHz
L1:    D-cache 32 kB enabled
       I-cache 32 kB enabled
Board: P1020RDB RevD
I2C:   ready
SPI:   ready
DRAM:  Configuring DDR for 666.667 MT/s data rate
DDR: 512 MB
NOR Flash Bank : Primary
SD/MMC : 4-bit Mode
eSPI : Enabled
FLASH: 16 MB
L2:    256 KB enabled
NAND:  32 MiB
MMC:  FSL_ESDHC: 0
EEPROM: Read failed.
    eTSEC2 is in sgmii mode.

    PCIE2 connected to Slot 1 as Root Complex (base addr ffe09000)
    PCIE2 on bus 00 - 01

    PCIE1 connected to Slot 2 as Root Complex (base addr ffe0a000)
    PCIE1 on bus 02 - 02

In:    serial
Out:   serial
Err:   serial
Net:   uploading VSC7385 microcode from ef000000
eTSEC1: No support for PHY id ffffffff; assuming generic
eTSEC1, eTSEC2, eTSEC3

Thanks.

Felix.