[U-Boot] [PATCH] ARM: remove unused ATAG

[Wolfgang Denk]

Dear "Martin Krause",

In message <47F3F98010FF784EBEE6526EAAB078D10635E720 at tq-mailsrv.tq-net.de> you wrote:
> 
> > Should we remove the whole trab support, then?
> 
> If it helps in any way to make U-Boot better (make the code more
> maintainable, remove some special configuration options, which are
> only used on trab board, etc.), and no one has objections, then=20
> the whole trab board support can be removed.

OK, I'll keep this in mind. So far the board support is still somewhat
useful as I use it as test case for s3c2400 processors, but as soon as
this board should cause troube that would require efforts we will
consider dropping it.

Thanks for the feedback.

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
"Where humor is concerned there are no standards -- no  one  can  say
what is good or bad, although you can be sure that everyone will.
- John Kenneth Galbraith