[U-Boot] [PATCH v5 00/18] Network support for spear platforms and SPEAr1300

[Armando VISCONTI]

Tom, Wolfgang,

THis time everything should be ok.

Thks for your attention,
Arm


Vipin KUMAR wrote:
> Dear Wolfgang, Tom,
>
> The following set of patches is the fifth iteration of patches for the following
> changes
> -> Network device driver for synopsys designware peripheral
> -> SPEAr1300 SoC support
> -> A few other misc changes and bugfixes
>
> These also include the feedbacks given by Tom and Ben
> These set of patches are rebased on e5ed138a23923ebe61843244748d98d3dbc04777
>
> Please include these changes in the mainline u-boot
>
> Regards
> Vipin
>
> Vipin KUMAR (18):
>   change_bit routine defined
>   SPEAr : SMI erase and write timeouts increased
>   SPEAr : Placing ethaddr write and read within CONFIG_CMD_NET
>   SPEAr : Reducing the max RAM size to 128MB
>   SPEAr : Basic arch related support added for SPEAr SoCs
>   SPEAr : Network driver support added
>   SPEAr : Network support configured for spear SoCs
>   SPEAr : macb driver support added for spear310 and spear320
>   SPEAr : FSMC driver support added
>   SPEAr : Configuring FSMC driver for NAND interface
>   SPEAr : i2c driver moved completely into drivers/i2c
>   SPEAr : smi driver moved completely into drivers/mtd
>   SPEAr : USB Device Controller driver support added
>   SPEAr : Supporting various configurations for spear3xx and spear6xx
>     boards
>   SPEAr : Basic spear1300 architecture support added
>   SPEAr : spear1300 SoC support added
>   SPEAr : Removing extraneous code
>   SPEAr : USB device controller bugfixes
>
>  MAINTAINERS                                        |    1 +
>  MAKEALL                                            |    1 +
>  Makefile                                           |   28 +-
>  arch/arm/cpu/arm926ejs/spear/Makefile              |    3 +-
>  arch/arm/cpu/arm926ejs/spear/cpu.c                 |   78 +++
>  arch/arm/cpu/arm_cortexa8/spear13xx/Makefile       |   52 ++
>  arch/arm/cpu/arm_cortexa8/spear13xx/cache.S        |  114 +++++
>  arch/arm/cpu/arm_cortexa8/spear13xx/cpu.c          |   96 ++++
>  .../arm_cortexa8/spear13xx/reset.c}                |   52 +--
>  arch/arm/cpu/arm_cortexa8/spear13xx/timer.c        |  138 +++++
>  .../arm/include/asm/arch-spear/clk.h               |   26 +-
>  arch/arm/include/asm/arch-spear/hardware.h         |   16 +-
>  arch/arm/include/asm/arch-spear/spr_misc.h         |    5 +
>  .../arm/include/asm/arch-spear13xx/hardware.h      |   33 +-
>  arch/arm/include/asm/arch-spear13xx/spr_gpt.h      |   85 ++++
>  arch/arm/include/asm/arch-spear13xx/spr_misc.h     |  317 ++++++++++++
>  .../arm/include/asm/arch-spear13xx/sys_proto.h     |   29 +-
>  arch/arm/include/asm/bitops.h                      |   11 +-
>  board/spear/common/Makefile                        |   10 +-
>  board/spear/common/spr_misc.c                      |   32 +-
>  board/spear/spear1300/Makefile                     |   51 ++
>  board/spear/spear1300/config.mk                    |   28 +
>  board/spear/spear1300/spear1300.c                  |   88 ++++
>  .../spear/spear1300/spr_lowlevel_init.S            |   35 +-
>  board/spear/spear300/config.mk                     |   11 -
>  board/spear/spear300/spear300.c                    |   18 +-
>  board/spear/spear310/config.mk                     |   11 -
>  board/spear/spear310/spear310.c                    |   35 ++-
>  board/spear/spear320/config.mk                     |   11 -
>  board/spear/spear320/spear320.c                    |   23 +-
>  board/spear/spear600/config.mk                     |   11 -
>  board/spear/spear600/spear600.c                    |   18 +-
>  doc/README.designware_eth                          |   25 +
>  doc/README.spear                                   |   46 ++-
>  drivers/i2c/Makefile                               |    2 +-
>  drivers/i2c/{spr_i2c.c => designware_i2c.c}        |    4 +-
>  .../spr_i2c.h => drivers/i2c/designware_i2c.h      |    6 +-
>  drivers/mtd/Makefile                               |    2 +-
>  drivers/mtd/nand/Makefile                          |    2 +-
>  drivers/mtd/nand/fsmc_nand.c                       |  366 ++++++++++++++
>  drivers/mtd/nand/spr_nand.c                        |  124 -----
>  drivers/mtd/{spr_smi.c => st_smi.c}                |   59 ++-
>  .../arch-spear/spr_smi.h => drivers/mtd/st_smi.h   |    8 +-
>  drivers/net/Makefile                               |    1 +
>  drivers/net/designware.c                           |  531 ++++++++++++++++++++
>  drivers/net/designware.h                           |  264 ++++++++++
>  drivers/serial/usbtty.h                            |    4 +-
>  drivers/usb/gadget/Makefile                        |    2 +-
>  drivers/usb/gadget/{spr_udc.c => designware_udc.c} |  116 +++--
>  include/configs/spear-common.h                     |   33 +-
>  include/configs/spear13xx_evb.h                    |  202 ++++++++
>  include/configs/{spear3xx.h => spear3xx_evb.h}     |   30 ++
>  include/configs/{spear6xx.h => spear6xx_evb.h}     |   13 +
>  include/linux/mtd/fsmc_nand.h                      |  104 ++++
>  include/netdev.h                                   |    1 +
>  include/usb/{spr_udc.h => designware_udc.h}        |    6 +-
>  56 files changed, 2997 insertions(+), 421 deletions(-)
>  create mode 100644 arch/arm/cpu/arm926ejs/spear/cpu.c
>  create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/Makefile
>  create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/cache.S
>  create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/cpu.c
>  rename arch/arm/{include/asm/arch-spear/spr_nand.h => cpu/arm_cortexa8/spear13xx/reset.c} (50%)
>  mode change 100644 => 100755
>  create mode 100644 arch/arm/cpu/arm_cortexa8/spear13xx/timer.c
>  copy include/configs/spear6xx.h => arch/arm/include/asm/arch-spear/clk.h (64%)
>  copy include/configs/spear6xx.h => arch/arm/include/asm/arch-spear13xx/hardware.h (58%)
>  create mode 100644 arch/arm/include/asm/arch-spear13xx/spr_gpt.h
>  create mode 100644 arch/arm/include/asm/arch-spear13xx/spr_misc.h
>  copy include/configs/spear6xx.h => arch/arm/include/asm/arch-spear13xx/sys_proto.h (64%)
>  create mode 100644 board/spear/spear1300/Makefile
>  create mode 100644 board/spear/spear1300/config.mk
>  create mode 100644 board/spear/spear1300/spear1300.c
>  copy include/configs/spear6xx.h => board/spear/spear1300/spr_lowlevel_init.S (56%)
>  create mode 100644 doc/README.designware_eth
>  rename drivers/i2c/{spr_i2c.c => designware_i2c.c} (98%)
>  rename arch/arm/include/asm/arch-spear/spr_i2c.h => drivers/i2c/designware_i2c.h (98%)
>  create mode 100644 drivers/mtd/nand/fsmc_nand.c
>  delete mode 100644 drivers/mtd/nand/spr_nand.c
>  rename drivers/mtd/{spr_smi.c => st_smi.c} (94%)
>  rename arch/arm/include/asm/arch-spear/spr_smi.h => drivers/mtd/st_smi.h (96%)
>  create mode 100644 drivers/net/designware.c
>  create mode 100644 drivers/net/designware.h
>  rename drivers/usb/gadget/{spr_udc.c => designware_udc.c} (91%)
>  create mode 100644 include/configs/spear13xx_evb.h
>  rename include/configs/{spear3xx.h => spear3xx_evb.h} (85%)
>  rename include/configs/{spear6xx.h => spear6xx_evb.h} (82%)
>  create mode 100644 include/linux/mtd/fsmc_nand.h
>  rename include/usb/{spr_udc.h => designware_udc.h} (98%)
>
>
>