[U-Boot] [PATCH 2/3] fsl_esdhc: Add function to reset the eSDHC controller

[Stefano Babic]

Kumar Gala wrote:
> From: Jerry Huang <Chang-Ming.Huang at freescale.com>
> 
> To support multiple block read command we must set abort or use auto
> CMD12.  If we booted from eSDHC controller neither of these are used
> and thus we need to reset the controller to allow multiple block read
> to function.
> 
> Signed-off-by: Jerry Huang <Chang-Ming.Huang at freescale.com>
> Signed-off-by: Roy Zang <tie-fei.zang at freescale.com>

Tested successfully on mx51evk.

Acked-by: Stefano Babic <sbabic at denx.de>

Regards,
Stefano

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================