[U-Boot] [PATCH] Add SPI support to mx51evk board
Stefano Babic
sbabic at denx.de
Mon Mar 22 11:32:06 CET 2010
Tom wrote:
> Stefano Babic wrote:
>> The patch adds SPI devices to the mx51evk board. Two devices
>> are supported: Atmel SPI flash and MC13892 power
>> controller.
>
> Is Atmel SPI flash already supported?
> It does not look like anything atmel is setup here
No, not yes, only in a future patch set. I must change the comment.
>
> This is dependent on the
> Added MC13892VK Power Management driver.
> These patches must be combined in a patchset.
Yes, they are. And with the changes in the SPI master (mxc_spi.c). I
will combine all three in a patchset.
>> +
>> +#define REV_ATLAS_LITE_1_0 0x8
>> +#define REV_ATLAS_LITE_1_1 0x9
>> +#define REV_ATLAS_LITE_2_0 0x10
>> +#define REV_ATLAS_LITE_2_1 0x11
>
> Move these define out of the function.
> Preferablly to an h-file
Ok
>> +
>> + slave = mc13892_spi_probe();
>
> The read / write routine bails if slave is invalid.
> It would be better to check earlier here and bail.
> As some of the logic of this function will still run and
> this would leave the hw in a bad state
You are right, I will fix it.
>> +#ifdef CONFIG_MXC_SPI
>> + setup_iomux_spi(1);
>> +#endif
>
> In board_late_init, for CONFIG_MXC_SPI, cs=0, here it is cs=1
> Is this correct?
> Please use a if-def here instead of the 0,1
> Maybe CONFIG_MC13892_SPI_PMIC_CS ?
Yes, that is correct. I will change it.
>> /*
>> + * SPI Configs
>> + * */
>
> Remove the extra '* '
Ok, thanks.
>> +
>> +#define MAX_SPI_BYTES (64 * 4)
>> +
> The patch
> 'Added MC13892VK Power Management driver.'
> Depends on this
> Move this #define's to that patch, or an earlier path in the patch set.
> These patches should be bi-sectable
Understood, I will move it.
Stefano
--
=====================================================================
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: office at denx.de
=====================================================================
More information about the U-Boot
mailing list