[U-Boot] [PATCH v4] cfi flash: add status polling method for amd flash

Thomas Chou thomas at wytron.com.tw
Wed Mar 24 03:29:21 CET 2010


This patch adds status polling method to offer an alternative to
data toggle method for amd flash chips.

This patch is needed for nios2 cfi flash interface, where the bus
controller performs 4 bytes read cycles for a single byte read
instruction. The data toggle method can not detect chip busy
status correctly. So we have to poll DQ7, which will be inverted
when the chip is busy.

This feature is enabled with the config def,
CONFIG_SYS_CFI_FLASH_STATUS_POLL

In flash_erase, the verbose printing of '.' is changed that it will
go with each sector whether successed or failed.

Signed-off-by: Thomas Chou <thomas at wytron.com.tw>
---
 drivers/mtd/cfi_flash.c |   95 +++++++++++++++++++++++++++++++++++++++++++----
 1 files changed, 87 insertions(+), 8 deletions(-)

diff --git a/drivers/mtd/cfi_flash.c b/drivers/mtd/cfi_flash.c
index cd1a86e..aae93bd 100644
--- a/drivers/mtd/cfi_flash.c
+++ b/drivers/mtd/cfi_flash.c
@@ -605,6 +605,63 @@ static int flash_full_status_check (flash_info_t * info, flash_sect_t sector,
 	return retcode;
 }
 
+static int use_flash_status_poll(flash_info_t *info)
+{
+#ifdef CONFIG_SYS_CFI_FLASH_STATUS_POLL
+	if (info->vendor == CFI_CMDSET_AMD_EXTENDED ||
+	    info->vendor == CFI_CMDSET_AMD_STANDARD)
+		return 1;
+#endif
+	return 0;
+}
+
+static int flash_status_poll(flash_info_t *info, void *src, void *dst,
+			     ulong tout, char *prompt)
+{
+#ifdef CONFIG_SYS_CFI_FLASH_STATUS_POLL
+	ulong start;
+	int ready;
+
+#if CONFIG_SYS_HZ != 1000
+	if ((ulong)CONFIG_SYS_HZ > 100000)
+		tout *= (ulong)CONFIG_SYS_HZ / 1000;  /* for a big HZ, avoid overflow */
+	else
+		tout = DIV_ROUND_UP(tout * (ulong)CONFIG_SYS_HZ, 1000);
+#endif
+
+	/* Wait for command completion */
+	start = get_timer(0);
+	while (1) {
+		switch (info->portwidth) {
+		case FLASH_CFI_8BIT:
+			ready = flash_read8(dst) == flash_read8(src);
+			break;
+		case FLASH_CFI_16BIT:
+			ready = flash_read16(dst) == flash_read16(src);
+			break;
+		case FLASH_CFI_32BIT:
+			ready = flash_read32(dst) == flash_read32(src);
+			break;
+		case FLASH_CFI_64BIT:
+			ready = flash_read64(dst) == flash_read64(src);
+			break;
+		default:
+			ready = 0;
+			break;
+		}
+		if (ready)
+			break;
+		if (get_timer(start) > tout) {
+			printf("Flash %s timeout at address %lx data %lx\n",
+			       prompt, (ulong)dst, (ulong)flash_read8(dst));
+			return ERR_TIMOUT;
+		}
+		udelay(1);		/* also triggers watchdog */
+	}
+#endif /* CONFIG_SYS_CFI_FLASH_STATUS_POLL */
+	return ERR_OK;
+}
+
 /*-----------------------------------------------------------------------
  */
 static void flash_add_byte (flash_info_t * info, cfiword_t * cword, uchar c)
@@ -752,7 +809,12 @@ static int flash_write_cfiword (flash_info_t * info, ulong dest,
 	if (!sect_found)
 		sect = find_sector (info, dest);
 
-	return flash_full_status_check (info, sect, info->write_tout, "write");
+	if (use_flash_status_poll(info))
+		return flash_status_poll(info, &cword, dstaddr,
+					 info->write_tout, "write");
+	else
+		return flash_full_status_check(info, sect,
+					       info->write_tout, "write");
 }
 
 #ifdef CONFIG_SYS_FLASH_USE_BUFFER_WRITE
@@ -914,9 +976,15 @@ static int flash_write_cfibuffer (flash_info_t * info, ulong dest, uchar * cp,
 		}
 
 		flash_write_cmd (info, sector, 0, AMD_CMD_WRITE_BUFFER_CONFIRM);
-		retcode = flash_full_status_check (info, sector,
-						   info->buffer_write_tout,
-						   "buffer write");
+		if (use_flash_status_poll(info))
+			retcode = flash_status_poll(info, src - (1 << shift),
+						    dst - (1 << shift),
+						    info->buffer_write_tout,
+						    "buffer write");
+		else
+			retcode = flash_full_status_check(info, sector,
+							  info->buffer_write_tout,
+							  "buffer write");
 		break;
 
 	default:
@@ -1001,10 +1069,21 @@ int flash_erase (flash_info_t * info, int s_first, int s_last)
 				break;
 			}
 
-			if (flash_full_status_check
-			    (info, sect, info->erase_blk_tout, "erase")) {
-				rcode = 1;
-			} else if (flash_verbose)
+			if (use_flash_status_poll(info)) {
+				cfiword_t cword = (cfiword_t)0xffffffffffffffffULL;
+				void *dest;
+				dest = flash_map(info, sect, 0);
+				if (flash_status_poll(info, &cword, dest,
+						      info->erase_blk_tout, "erase"))
+					rcode = 1;
+				flash_unmap(info, sect, 0, dest);
+			} else {
+				if (flash_full_status_check(info, sect,
+							    info->erase_blk_tout,
+							    "erase"))
+					rcode = 1;
+			}
+			if (flash_verbose)
 				putc ('.');
 		}
 	}
-- 
1.6.6.1



More information about the U-Boot mailing list