[U-Boot] [PATCH 1/4] SPEAr : SMI erase and write timeouts increased

[Vipin KUMAR]

On 3/29/2010 3:21 AM, Tom wrote:
> Vipin KUMAR wrote:
>> SMI driver fails because of low timeout values. Increasing the erase
>> and write
>> timeouts to 3 seconds
> 
> This is a huge timeout change.
> 2ms to 3000ms.
> If something goes wrong, it will seem like the board is hung.
> Is this ok?
> 

2ms timeout itself was a mistake. 3 sec is OK. Offcourse, 3 secs are
required only when something goes wrong

>>
>> Signed-off-by: Vipin Kumar <vipin.kumar at st.com>
>> ---
>>  drivers/mtd/spr_smi.c                |    8 ++++----
>>  include/asm-arm/arch-spear/spr_smi.h |    6 +++---
>>  2 files changed, 7 insertions(+), 7 deletions(-)
>>
>> diff --git a/drivers/mtd/spr_smi.c b/drivers/mtd/spr_smi.c
>> index 9a70a19..189ee6d 100755
>> --- a/drivers/mtd/spr_smi.c
>> +++ b/drivers/mtd/spr_smi.c
>> @@ -60,11 +60,11 @@ static struct flash_dev flash_ids[] = {
>>   */
>>  static void smi_wait_xfer_finish(int timeout)
>>  {
>> -    while (timeout--) {
>> +    do {
>>          if (readl(&smicntl->smi_sr) & TFF)
>>              break;
>>          udelay(1000);
>> -    }
>> +    } while (timeout--);
> 
> This changes the function to wait at least 1ms even if timeout == 0.
> Why was the original logic changed?
> 

Earlier a value of 2 was reading the status register only once. This I
felt is more appropriate since the status register is read every ms and
at least once.

>>  }
>>  
>>  /*
>> @@ -215,11 +215,11 @@ static int smi_write_enable(int bank)
>>      /* Restore the CTRL REG1 state */
>>      writel(ctrlreg1, &smicntl->smi_cr1);
>>  
>> -    while (timeout--) {
>> +    do {
>>          if (smi_read_sr(bank) & (1 << (bank + WM_SHIFT)))
>>              break;
>>          udelay(1000);
>> -    }
>> +    } while (timeout--);
>>  
>>      if (timeout)
>>          return 0;
>> diff --git a/include/asm-arm/arch-spear/spr_smi.h
>> b/include/asm-arm/arch-spear/spr_smi.h
>> index 06df745..e2e5e8f 100755
>> --- a/include/asm-arm/arch-spear/spr_smi.h
>> +++ b/include/asm-arm/arch-spear/spr_smi.h
>> @@ -108,8 +108,8 @@ struct flash_dev {
>>      ushort sector_count;
>>  };
>>  
>> -#define SFLASH_PAGE_SIZE    0x100    /* flash page size */
>> -#define XFER_FINISH_TOUT    2    /* xfer finish timeout */
>> -#define WMODE_TOUT        2    /* write enable timeout */
>> +#define SFLASH_PAGE_SIZE    0x100        /* flash page size */
>> +#define XFER_FINISH_TOUT    (3 * CONFIG_SYS_HZ)
>> +#define WMODE_TOUT        (3 * CONFIG_SYS_HZ)
>>  
>>  #endif
> 
> Tom
>