[U-Boot] Defer net initialization

[Wolfgang Denk]

Dear Alexander Stein,

In message <201005311458.18454.alexander.stein at systec-electronic.com> you wrote:
> 
> during board setup the ethernet is configured including the PHY. This takes an 
> amount of time even if the cable is plugged in. It takes even more time of the 
> initialization runs into a timeout if no cable is put in.
> Is there a possibility to defer the net initialization up to that point where 
> the first net access is done, e.g. tftp command and leave the net 
> uninitialized during normal startup using fsload and bootm.

Which version of U-Boot and which architecture / board are you talking
about?

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
PoB = "Prisoner of Bill" -- those held captive, unwillingly or other-
wise, by the contemptible Microsoft monopoly.
         -- Tom Christiansen in <6abo45$3lc$2 at csnews.cs.colorado.edu>