[U-Boot] AVR32 / ATNGW100 FLASH adressing issues

[Wolfgang Denk]

Dear Reinhard Meyer,

In message <4C03C0CA.50504 at emk-elektronik.de> you wrote:
>
> currently the actual u-Boot (U-Boot 2010.03-00351-g40792d6-dirty) for 
> AVR32/ATNGW100 defines FLASH to be at 0x00000000 (which is the true 
> physical address):
...
> however the "flinfo" command show FLASH to be at 0xa0000000 (which is 
> translated to 0x00000000 by default)
...
> I think that the issue should be fixed by making sure FLASH is detected 
> at 0x00000000 and NOT at 0xa0000000, correct?

This has been discussed in one of the longer and more heated
discussions on that list; see thread starting here:
http://thread.gmane.org/gmane.comp.boot-loaders.u-boot/66904

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
The only thing necessary for the triumph of evil is for good  men  to
do nothing.                                            - Edmund Burke