[U-Boot] [PATCH 29/37] Blackfin: bf526-ezbrd: enable BootROM-OOB layout when booting from NAND

[Mike Frysinger]

We need to use the Blackfin BootROM-specific OOB layout when we boot out
of NAND as that is what the on-chip ROM expects.

Also need to increase the monitor size a little to accommodate the extra
NAND code overhead.

Signed-off-by: Mike Frysinger <vapier at gentoo.org>
---
 include/configs/bf526-ezbrd.h |    5 +++--
 1 files changed, 3 insertions(+), 2 deletions(-)

diff --git a/include/configs/bf526-ezbrd.h b/include/configs/bf526-ezbrd.h
index eeca9ca..4c30c25 100644
--- a/include/configs/bf526-ezbrd.h
+++ b/include/configs/bf526-ezbrd.h
@@ -52,7 +52,7 @@
 #define CONFIG_EBIU_AMBCTL0_VAL	(B1WAT_15 | B1RAT_15 | B1HT_3 | B1RDYPOL | B0WAT_15 | B0RAT_15 | B0HT_3 | B0RDYPOL)
 #define CONFIG_EBIU_AMBCTL1_VAL	(B3WAT_15 | B3RAT_15 | B3HT_3 | B3RDYPOL | B2WAT_15 | B2RAT_15 | B2HT_3 | B2RDYPOL)
 
-#define CONFIG_SYS_MONITOR_LEN	(512 * 1024)
+#define CONFIG_SYS_MONITOR_LEN	(768 * 1024)
 #define CONFIG_SYS_MALLOC_LEN	(512 * 1024)
 
 
@@ -61,7 +61,8 @@
  * (can't be used same time as ethernet)
  */
 #if (CONFIG_BFIN_BOOT_MODE == BFIN_BOOT_NAND)
-#define CONFIG_BFIN_NFC
+# define CONFIG_BFIN_NFC
+# define CONFIG_BFIN_NFC_BOOTROM_ECC
 #endif
 #ifdef CONFIG_BFIN_NFC
 #define CONFIG_BFIN_NFC_CTL_VAL	0x0033
-- 
1.7.3.1