[U-Boot] [PATCH] da850evm : enable NAND even when not in NAND boot mode

[Ben Gardiner]

There is currently no NAND pinmux enabled by the da850evm board setup code.
This is fine when booting from NAND since the early boot code (UBL) will setup
the pinmux; however, when the boot mode is any other setting NAND is unusable
when enabled in the config.

This patch adds a pinmux list for NAND and enables it when NAND is enabled in
the config. Tested by booting from SPI on the da850evm and verifying NAND
was usable.

Signed-off-by: Ben Gardiner <bengardiner at nanometrics.ca>
CC: Nick Thompson <nick.thompson at ge.com>
To: Sudhakar Rajashekhara <sudhakar.raj at ti.com>

---

Note: there is precendent for NAND configuration by u-boot independent of the
selected boot mode; see commit 26be2c53d671ecfd3e0483f0870649ac28322293 by
Nick Thompson <nick.thompson at ge.com> "Davinci: NAND enable ECC even when not in
NAND boot mode"

---

 board/davinci/da8xxevm/da850evm.c |   22 ++++++++++++++++++++++
 1 files changed, 22 insertions(+), 0 deletions(-)

diff --git a/board/davinci/da8xxevm/da850evm.c b/board/davinci/da8xxevm/da850evm.c
index eeb456c..f84adb9 100644
--- a/board/davinci/da8xxevm/da850evm.c
+++ b/board/davinci/da8xxevm/da850evm.c
@@ -54,12 +54,34 @@ static const struct pinmux_config i2c_pins[] = {
 	{ pinmux(4), 2, 3 }
 };
 
+#ifdef CONFIG_NAND_DAVINCI
+const struct pinmux_config nand_pins[] = {
+	{ pinmux(7), 1, 1 },
+	{ pinmux(7), 1, 2 },
+	{ pinmux(7), 1, 4 },
+	{ pinmux(7), 1, 5 },
+	{ pinmux(9), 1, 0 },
+	{ pinmux(9), 1, 1 },
+	{ pinmux(9), 1, 2 },
+	{ pinmux(9), 1, 3 },
+	{ pinmux(9), 1, 4 },
+	{ pinmux(9), 1, 5 },
+	{ pinmux(9), 1, 6 },
+	{ pinmux(9), 1, 7 },
+	{ pinmux(12), 1, 5 },
+	{ pinmux(12), 1, 6 }
+};
+#endif
+
 static const struct pinmux_resource pinmuxes[] = {
 #ifdef CONFIG_SPI_FLASH
 	PINMUX_ITEM(spi1_pins),
 #endif
 	PINMUX_ITEM(uart_pins),
 	PINMUX_ITEM(i2c_pins),
+#ifdef CONFIG_NAND_DAVINCI
+	PINMUX_ITEM(nand_pins),
+#endif
 };
 
 static const struct lpsc_resource lpsc[] = {
-- 
1.7.0.4