[U-Boot] [PATCH] arm926ejs, suen3: fix relocation issues
Prafulla Wadaskar
prafulla at marvell.com
Wed Oct 20 12:21:09 CEST 2010
> -----Original Message-----
> From: Prafulla Wadaskar
> Sent: Tuesday, October 19, 2010 4:35 PM
> To: 'Eric Cooper'; Heiko Schocher
> Cc: u-boot at lists.denx.de
> Subject: RE: [PATCH] arm926ejs, suen3: fix relocation issues
>
>
>
> > -----Original Message-----
> > From: Eric Cooper [mailto:ecc at cmu.edu]
> > Sent: Tuesday, October 19, 2010 4:14 PM
> > To: Heiko Schocher
> > Cc: Prafulla Wadaskar; u-boot at lists.denx.de
> > Subject: Re: [PATCH] arm926ejs, suen3: fix relocation issues
> >
> > > Maybe, Eric (added to cc: ) should also try to do early
> things (like
> > > kirkwood_mpp_conf()) in board_early_init_f() as I on the suen3?
> >
> > I will try this and let you know. But the most helpful
> data point for
> > me would be whether display_banner etc. currently works on a
> > SheevaPlug, which is almost identical to the DockStar.
>
> Hi Eric
> I checked on Sheevaplug, but sheevaplug has usb-UART
> interface, that does not help to test this.
> Since by the time UART is up board is in booted state.
>
> There is anther way to test this, erase native u-boot and
> check from boot from DRAM, I have not tested this yet.
>
> But I think this must be problem on sheevaplug too ?
Crosschecked, This problem is on all the Kirkwood boards,
I am posting fix up patch for all Marvell boards.
Regards..
Prafulla . .
More information about the U-Boot
mailing list