[U-Boot] [PATCH] cfi_flash: Add optional config register write to cfi-detection

[Stefan Roese]

This patch adds the possibility to (optinally) write to the
flash configuration register. The Intel style CFI chips support
such a register that can be used to configure the operation
mode to a non-default value.

This method will be used by the t3corp board, which needs to
configure the DS617 Xilinx flash for async read mode.

Signed-off-by: Stefan Roese <sr at denx.de>
---
 drivers/mtd/cfi_flash.c |   43 +++++++++++++++++++++++++++++++++++++++++++
 include/mtd/cfi_flash.h |    2 ++
 2 files changed, 45 insertions(+), 0 deletions(-)

diff --git a/drivers/mtd/cfi_flash.c b/drivers/mtd/cfi_flash.c
index c17c542..6e617f0 100644
--- a/drivers/mtd/cfi_flash.c
+++ b/drivers/mtd/cfi_flash.c
@@ -74,6 +74,20 @@ flash_info_t flash_info[CFI_MAX_FLASH_BANKS];	/* FLASH chips info */
 #define CONFIG_SYS_FLASH_CFI_WIDTH	FLASH_CFI_8BIT
 #endif
 
+/*
+ * 0xffff is an undefined value for the configuration register. When
+ * this value is returned, the configuration register shall not be
+ * written at all (default mode).
+ */
+static u16 cfi_flash_config_reg(int i)
+{
+#ifdef CONFIG_SYS_CFI_FLASH_CONFIG_REGS
+	return ((u16 [])CONFIG_SYS_CFI_FLASH_CONFIG_REGS)[i];
+#else
+	return 0xffff;
+#endif
+}
+
 #if defined(CONFIG_SYS_MAX_FLASH_BANKS_DETECT)
 int cfi_flash_num_flash_banks = CONFIG_SYS_MAX_FLASH_BANKS_DETECT;
 #endif
@@ -2031,6 +2045,31 @@ void flash_set_verbose(uint v)
 	flash_verbose = v;
 }
 
+static void cfi_flash_set_config_reg(u32 base, u16 val)
+{
+#ifdef CONFIG_SYS_CFI_FLASH_CONFIG_REGS
+	/*
+	 * Only set this config register if really defined
+	 * to a valid value (0xffff is invalid)
+	 */
+	if (val == 0xffff)
+		return;
+
+	/*
+	 * Set configuration register. Data is "encrypted" in the 16 lower
+	 * address bits.
+	 */
+	flash_write16(FLASH_CMD_SETUP, (void *)(base + (val << 1)));
+	flash_write16(FLASH_CMD_SET_CR_CONFIRM, (void *)(base + (val << 1)));
+
+	/*
+	 * Finally issue reset-command to bring device back to
+	 * read-array mode
+	 */
+	flash_write16(FLASH_CMD_RESET, (void *)base);
+#endif
+}
+
 /*-----------------------------------------------------------------------
  */
 unsigned long flash_init (void)
@@ -2054,6 +2093,10 @@ unsigned long flash_init (void)
 	for (i = 0; i < CONFIG_SYS_MAX_FLASH_BANKS; ++i) {
 		flash_info[i].flash_id = FLASH_UNKNOWN;
 
+		/* Optionally write flash configuration register */
+		cfi_flash_set_config_reg(cfi_flash_bank_addr(i),
+					 cfi_flash_config_reg(i));
+
 		if (!flash_detect_legacy(cfi_flash_bank_addr(i), i))
 			flash_get_size(cfi_flash_bank_addr(i), i,
 					cfi_flash_bank_size(i));
diff --git a/include/mtd/cfi_flash.h b/include/mtd/cfi_flash.h
index 2ff00f2..3245b44 100644
--- a/include/mtd/cfi_flash.h
+++ b/include/mtd/cfi_flash.h
@@ -32,6 +32,8 @@
 #define FLASH_CMD_ERASE_CONFIRM		0xD0
 #define FLASH_CMD_WRITE			0x40
 #define FLASH_CMD_PROTECT		0x60
+#define FLASH_CMD_SETUP			0x60
+#define FLASH_CMD_SET_CR_CONFIRM	0x03
 #define FLASH_CMD_PROTECT_SET		0x01
 #define FLASH_CMD_PROTECT_CLEAR		0xD0
 #define FLASH_CMD_CLEAR_STATUS		0x50
-- 
1.7.3.2