[U-Boot] Does U-boot supports STM28W160C NOR Flash?

sudeep balan bsudeep at gmail.com
Thu Oct 28 12:07:46 CEST 2010


Hello,

I am having a board with MCF5485 Coldfire processor. I cannot save the
parameters in uboot. Whether Uboot support STM28W160C NOR flash.

I having a error shown below while saving the uboot parameters.

-> save
Saving Environment to Flash...
. done
Un-Protected 1 sectors
Erasing Flash...
. done
Erased 1 sectors
Writing to Flash... Flash not Erased
. done
Protected 1 sectors


U-Boot 2010.06-rc2 (Oct 26 2010 - 13:23:00)

CPU:   Freescale MCF5485
       CPU CLK 200 MHz BUS CLK 100 MHz
Board: Freescale FireEngine 5485 EVB
I2C:   ready
DRAM:  64 MiB
FLASH: 18 MiB
*** Warning - bad CRC, using default environment

In:    serial
Out:   serial
Err:   serial
Net:   FEC0, FEC1

regards,
Sudeep


More information about the U-Boot mailing list