[U-Boot] [PATCH 3/3 V3] Add board support for hawkboard

[Detlev Zundel]

Hi Sughosh,

[...]

> * hawkboard_nand_config - Used to generate the secondary
>  bootloader(nand_spl) image. This creates an elf file u-boot-spl
>  under nand_spl/. Create an AIS signed image using this file, and
>  flash it to the nand flash at address 0x20000. The ais file should
>  fit in one block.

Could you elaborate on "create an AIS signed image" a little bit for
people who are not intimately familiar with this architecture?  Maybe
you can add a small doc/README.da8xx for that purpose?

> * hawkboard_uart_config - This is same as the first image, but with
>  the TEXT_BASE as expected by the RBL(0xc1080000). Create the AIS
>  Signed bin, as use the normal UART boot procedure to boot the image.

Again a short step-by-step instruction in a readme file would be a very
valuable addition.

Thanks
  Detlev

-- 
UN Resolution by the General Assembly on December 31, 1988 condemning
"Terrorism Wherever and by Whomever Committed":  153 votes to 2.
The two voting /against/ the resolution were the US and Israel...
--
DENX Software Engineering GmbH,      MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich,  Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-40 Fax: (+49)-8142-66989-80 Email: dzu at denx.de