[U-Boot] [PATCH] fsl_pci_init: Make fsl_pci_init_port() PCI/PCIe aware

Peter Tyser ptyser at xes-inc.com
Thu Oct 28 22:24:59 CEST 2010


Previously fsl_pci_init_port() always assumed that a port was a PCIe
port and would incorrectly print messages for a PCI port such as the
following on bootup:
    PCI1:  32 bit, 33 MHz, sync, host, arbiter
                Scanning PCI bus 00
    PCIE1 on bus 00 - 00

This change corrects the output of fsl_pci_init_port():
    PCI1:  32 bit, 33 MHz, sync, host, arbiter
                Scanning PCI bus 00
    PCI1 on bus 00 - 00

Signed-off-by: Peter Tyser <ptyser at xes-inc.com>
---
Tested on a MPC8548 with PCI, and a MPC8640 with PCIe

 drivers/pci/fsl_pci_init.c |    6 +++++-
 1 files changed, 5 insertions(+), 1 deletions(-)

diff --git a/drivers/pci/fsl_pci_init.c b/drivers/pci/fsl_pci_init.c
index 1f02103..45794da 100644
--- a/drivers/pci/fsl_pci_init.c
+++ b/drivers/pci/fsl_pci_init.c
@@ -441,6 +441,8 @@ int fsl_pci_init_port(struct fsl_pci_info *pci_info,
 {
 	volatile ccsr_fsl_pci_t *pci;
 	struct pci_region *r;
+	pci_dev_t dev = PCI_BDF(busno,0,0);
+	u8 pcie_cap;
 
 	pci = (ccsr_fsl_pci_t *) pci_info->regs;
 
@@ -479,7 +481,9 @@ int fsl_pci_init_port(struct fsl_pci_info *pci_info,
 		hose->last_busno = hose->first_busno;
 	}
 
-	printf("    PCIE%x on bus %02x - %02x\n", pci_info->pci_num,
+	pci_hose_read_config_byte(hose, dev, FSL_PCIE_CAP_ID, &pcie_cap);
+	printf("    PCI%s%x on bus %02x - %02x\n", pcie_cap == PCI_CAP_ID_EXP ?
+			"E" : "", pci_info->pci_num,
 			hose->first_busno, hose->last_busno);
 
 	return(hose->last_busno + 1);
-- 
1.7.0.4



More information about the U-Boot mailing list