[U-Boot] [PATCH] net, davinci_emac: make clock divider in MDIO control register configurable

Heiko Schocher hs at denx.de
Tue Aug 2 08:21:03 CEST 2011


Define CONFIG_SYS_EMAC_TI_CLKDIV for setting the clkdiv value
in the MDIO control register.

Signed-off-by: Heiko Schocher <hs at denx.de>
cc: Sandeep Paulraj <s-paulraj at ti.com>
cc: Wolfgang Denk <wd at denx.de>
---
 drivers/net/davinci_emac.c |    9 +++++++--
 1 files changed, 7 insertions(+), 2 deletions(-)

diff --git a/drivers/net/davinci_emac.c b/drivers/net/davinci_emac.c
index 66c0d13..c911b64 100644
--- a/drivers/net/davinci_emac.c
+++ b/drivers/net/davinci_emac.c
@@ -53,6 +53,11 @@ unsigned int	emac_dbg = 0;
 #define emac_gigabit_enable()	/* no gigabit to enable */
 #endif
 
+#if !defined(CONFIG_SYS_EMAC_TI_CLKDIV)
+#define CONFIG_SYS_EMAC_TI_CLKDIV	((EMAC_MDIO_BUS_FREQ / \
+		EMAC_MDIO_CLOCK_FREQ) - 1)
+#endif
+
 static void davinci_eth_mdio_enable(void);
 
 static int gen_init_phy(int phy_addr);
@@ -126,7 +131,7 @@ static void davinci_eth_mdio_enable(void)
 {
 	u_int32_t	clkdiv;
 
-	clkdiv = (EMAC_MDIO_BUS_FREQ / EMAC_MDIO_CLOCK_FREQ) - 1;
+	clkdiv = CONFIG_SYS_EMAC_TI_CLKDIV;
 
 	writel((clkdiv & 0xff) |
 	       MDIO_CONTROL_ENABLE |
@@ -427,7 +432,7 @@ static int davinci_eth_open(struct eth_device *dev, bd_t *bis)
 #endif
 
 	/* Init MDIO & get link state */
-	clkdiv = (EMAC_MDIO_BUS_FREQ / EMAC_MDIO_CLOCK_FREQ) - 1;
+	clkdiv = CONFIG_SYS_EMAC_TI_CLKDIV;
 	writel((clkdiv & 0xff) | MDIO_CONTROL_ENABLE | MDIO_CONTROL_FAULT,
 	       &adap_mdio->CONTROL);
 
-- 
1.7.6



More information about the U-Boot mailing list