[U-Boot] [PATCH v2] arm/kirkwood: print speeds with cpu info.

[Prafulla Wadaskar]

> -----Original Message-----
> From: Jason [mailto:u-boot at lakedaemon.net]
> Sent: Tuesday, August 02, 2011 6:34 PM
> To: wd at denx.de; Prafulla Wadaskar
> Cc: u-boot at lists.denx.de; clint at debian.org; Prabhanjan Sarnaik; Ashish
> Karkare; Siddarth Gore; bdale at gag.com; simon at sequanux.org
> Subject: Re: [PATCH v2] arm/kirkwood: print speeds with cpu info.
> 
> Wolfgang,
> 
> On Mon, Aug 01, 2011 at 01:04:27AM +0000, Jason Cooper wrote:
> > If CONFIG_DISPLAY_CPUINFO is enabled on kirkwood SoCs, this will print
> the
> > speeds of the various components.
> >
> > Signed-off-by: Jason Cooper <u-boot at lakedaemon.net>
> > ---
> > Changes since v1:
> > 	- optimized macros to remove one-timers
> > 	- reduced switch/case to if/else since it operates on one bit.
> > 	- remove RFC
> >
> >  arch/arm/cpu/arm926ejs/kirkwood/cpu.c    |   41
> ++++++++++++++++++++++++++++++
> >  arch/arm/include/asm/arch-kirkwood/cpu.h |    1 +
> >  2 files changed, 42 insertions(+), 0 deletions(-)
> >
> 
> Please drop this patch.  It's cosmetic, becoming a hassle to do
> properly, and doesn't move me towards my goal of mainline dreamplug
> support.

Hi Jason
I think this is useful information to be displayed.
Thanks for your effort so far on this patch, and I wish that should not go waste.

You can think of supporting this once your dreamplug is supported :-)

Regards..
Prafulla . .