[U-Boot] [PATCH] beagleboard: enable HUB power on all variants of the BeagleBoard

[Joel A Fernandes]

From: Christian Spielberger <c.spielberger at bct-electronic.com>

Signed-off-by: Joel A Fernandes <joelagnel at ti.com>
Cc: "Eric Bénard" <eric at eukrea.com>
Cc: "Christian Spielberger" <c.spielberger at bct-electronic.com>
---
Pushing this patch myself as no one else did.

Previous discussions:
http://article.gmane.org/gmane.comp.boot-loaders.u-boot/105663/
http://article.gmane.org/gmane.comp.boot-loaders.u-boot/101540/

 board/ti/beagle/beagle.c |   10 +++++++++-
 1 files changed, 9 insertions(+), 1 deletions(-)

diff --git a/board/ti/beagle/beagle.c b/board/ti/beagle/beagle.c
index 13fe39b..9d65e9e 100644
--- a/board/ti/beagle/beagle.c
+++ b/board/ti/beagle/beagle.c
@@ -332,7 +332,15 @@ int misc_init_r(void)
 		setenv(expansion_config.env_var, expansion_config.env_setting);
 
 	twl4030_power_init();
-	twl4030_led_init(TWL4030_LED_LEDEN_LEDAON | TWL4030_LED_LEDEN_LEDBON);
+	switch (get_board_revision()) {
+	case REVISION_XM_C:
+	case REVISION_C4:
+		twl4030_led_init(TWL4030_LED_LEDEN_LEDAON | TWL4030_LED_LEDEN_LEDBON);
+		break;
+	default:
+		twl4030_led_init(TWL4030_LED_LEDEN_LEDBON);
+		break;
+	}
 
 	/* Set GPIO states before they are made outputs */
 	writel(GPIO23 | GPIO10 | GPIO8 | GPIO2 | GPIO1,
-- 
1.7.1