[U-Boot] [PATCH v4 1/8] MX5: Add initial support for MX53 processor

Wolfgang Denk wd at denx.de
Mon Jan 10 00:20:17 CET 2011


Dear Jason Liu,

In message <1294129662-680-1-git-send-email-r64343 at freescale.com> you wrote:
> Add initial support for Freescale MX53 processor,
> 
> - Add the iomux support and the pin definition,
> - Add the regs definition, clean up some unused def from mx51,
> - Add the low level init support, make use the freq input of setup_pll macro
...
> +	ldr r0, =\pll
...
> +	ldr r1, W_DP_OP_\freq

Please see previous post.  What do these escape sequences mean?

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
The only solution is ... a balance of power. We  arm  our  side  with
exactly  that  much  more.  A balance of power -- the trickiest, most
difficult, dirtiest game of them all. But the only one that preserves
both sides.
	-- Kirk, "A Private Little War", stardate 4211.8


More information about the U-Boot mailing list