[U-Boot] [PATCH 2/2] SPI: mxc_spi: add SPI clock calculation and setup to the driver

[Stefano Babic]

On 01/16/2011 07:17 PM, Anatolij Gustschin wrote:
> The MXC SPI driver didn't calculate the SPI clock up to
> now and just used lowest possible divider 512 for DATA
> RATE in the control register. This results in very low
> transfer rates.
> 

Hi August,

I sent last friday a patch for mxc_spi.c, too, adding support for mx35,
and the two patches now conflict. Is it ok for you if I rebase your
patch on top of mine and I post it again ?

Best Regards,
Stefano

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================