[U-Boot] Uboot can't start kernel after change from version 2009.01 to 2010.09

[Andreas Bießmann]

Dear Maik Hänig,

please do not hijack a thread!

Am 25.01.2011 12:03, schrieb Maik Hänig:
> Dear Reinhard,
> 
> sorry I copied the wrong log:
> 
> U-Boot 2010.09 (Jan 24 2011 - 17:45:54)

Ok, you use 2010.09. This was last release before relocate changes.
Therefore it has no connection with the relocation stuff.

> I2C:   ready
> DRAM:  64 MiB
> Flash: 32 MiB
> In:    serial
> Out:   serial
> Err:   serial
> Hit any key to stop autoboot:  0
> ## Booting kernel from Legacy Image at 30060000 ...
>     Image Name:   Linux Kernel
>     Image Type:   ARM Linux Kernel Image (gzip compressed)
>     Data Size:    1084127 Bytes = 1 MiB
>     Load Address: 20008000
>     Entry Point:  20008000
>     Verifying Checksum ... OK
>     Uncompressing Kernel Image ... OK
> 
> Starting kernel ...
> 
> I have to kernel Images in flash. The bootcmd is copied from printenv. 
> With the uboot version 2009.01 it works well. 


> Is it nessesary to set a 
> console parameter in the bootcmd in uboot version 2010.09?

We don't know your configuration. What tells your working setup in
kernel log messages about 'Command line'? -> /proc/cmdline

> 
> 
> Mit freundlichen Grüßen
> 
> Maik Hänig
> 
> Am 25.01.2011 11:54, schrieb Reinhard Meyer:
>> Dear Maik Hänig,
>>> Hi,
>>>
>>>
>>> I change my uboot version and after it the uboot don't starts the same
>>> linux kernel:
>>>
>>> ## Booting kernel from Legacy Image at 10060000 ...
>> _________________________________________????????
>>>      Image Name:   Linux Kernel
>>>      Image Type:   ARM Linux Kernel Image (gzip compressed)
>>>      Data Size:    1178673 Bytes = 1.1 MiB
>>>      Load Address: 20008000
>>>      Entry Point:  20008000
>>>      Verifying Checksum ... OK
>>>      Uncompressing Kernel Image ... OK
>>>
>>> Starting kernel ...
>>>
>>> *****LOG END*****
>>>
>>>
>>> It's a board simular to the at91rm9200dk. I start the kernel with

What is your board exactly? Is it currently in official u-boot or do you
have another tree?
at91rm9200dk is most likely broken with current u-boot (2010.12) and
will be removed for 2011.03. So if you have a at91rm9200dk at hand
please try to get the current u-boot working with that board and provide
patches. You may see my patches for at91rm9200ek which at least make
at91rm9200ek boot from SDRAM when setup correctly with an jtag (->
booting with at91bootstrab should also work but is untested).

regards

Andreas Bießmann