[U-Boot] [GIT pull] Please pull u-boot-mpc85xx
Wolfgang Denk
wd at denx.de
Mon Jul 11 22:12:32 CEST 2011
Dear Kumar Gala,
In message <alpine.LFD.2.00.1107111324480.27526 at right.am.freescale.net> you wrote:
> The following changes since commit 810cb19003ffe0115d10700fc512a2a743916f20:
>
> MPC83XX: Fix PCI express clock setup (2011-07-06 19:09:28 -0500)
>
> are available in the git repository at:
> git://git.denx.de/u-boot-mpc85xx master
>
> Felix Radensky (1):
> powerpc/85xx: Fix pin muxing for second USB controller
>
> Kumar Gala (4):
> powerpc/85xx: Fix compile errors if CONFIG_SYS_{B,Q}MAN_MEM_PHYS aren't set
> powerpc/85xx: Fix compile errors if CONFIG_SYS_{BR,OR}0_PRELIM aren't set
> powerpc/85xx: Fix compile errors if CONFIG_SYS_DPAA_QBMAN isn't set
> powerpc/85xx: Add P2041 processor support
>
> Mingkai Hu (1):
> powerpc/p2040: Add various p2040 specific information
>
> Ramneek Mehresh (5):
> qoriq/p1_p2_rdb: Add Dual Role USB support macro for P1020RDB
> powerpc/8xxx: Update USB mode device tree fixup
> powerpc/85xx: Specify hwconfig usage for USB controller
> qoriq/p1_p2_rdb: USB device-tree fixups for P1020
> powerpc/85xx: Add default usb mode and phy type to hwconfig
>
> Roy Zang (1):
> powerpc/85xx: Add basic support for P1023RDS board
>
> Shaohui Xie (1):
> powerpc/85xx: Add NAND boot support for P3041/P5020DS
>
> Timur Tabi (2):
> powerpc/86xx: display boot device and bank on the MPC8610 HPCD
> powerpc/85xx: remove SERDES4 soft-reset work-around
>
> York Sun (11):
> powerpc/mpc8xxx: adjust DDR burst length and chop accroding to sdram width
> powerpc/mpc8xxx: check SPD length before using part number
> powerpc/mpc8xxx: Add 16-bit support for DDR3
> Adding more SPD registers
> powerpc/mpc8xxx: Enable calculation for fixed DDR chips
> powerpc/mpc8xxx: Adding fallback to raw timing on supported boards
> powerpc/mpc8xxx: fix DDR data width checking
> powerpc/corenet_ds: Fix RCW overriding for RDIMM
> powerpc/mpc85xx: Display a warning for unsupported DDR data rates
> powerpc/mpc8xxx: Allow override DDR read-to-write turnaround time
> powerpc/corenet_ds: add back buffer write for NOR flash
>
> MAINTAINERS | 1 +
> README | 6 +
> arch/powerpc/cpu/mpc85xx/Makefile | 6 +
> arch/powerpc/cpu/mpc85xx/cpu.c | 4 +-
> arch/powerpc/cpu/mpc85xx/fsl_corenet_serdes.c | 71 ++-
> arch/powerpc/cpu/mpc85xx/p2040_ids.c | 109 +++++
> arch/powerpc/cpu/mpc85xx/p2040_serdes.c | 24 +
> arch/powerpc/cpu/mpc85xx/p3041_ids.c | 11 +-
> arch/powerpc/cpu/mpc85xx/p4080_ids.c | 13 +-
> arch/powerpc/cpu/mpc85xx/p5020_ids.c | 11 +-
> arch/powerpc/cpu/mpc8xxx/cpu.c | 2 +
> arch/powerpc/cpu/mpc8xxx/ddr/Makefile | 13 +-
> arch/powerpc/cpu/mpc8xxx/ddr/ctrl_regs.c | 3 +
> arch/powerpc/cpu/mpc8xxx/ddr/ddr.h | 7 +
> arch/powerpc/cpu/mpc8xxx/ddr/ddr3_dimm_params.c | 3 +-
> arch/powerpc/cpu/mpc8xxx/ddr/main.c | 34 ++-
> arch/powerpc/cpu/mpc8xxx/ddr/options.c | 44 ++-
> arch/powerpc/cpu/mpc8xxx/fdt.c | 77 +++-
> arch/powerpc/cpu/mpc8xxx/fsl_lbc.c | 2 +
> arch/powerpc/include/asm/config_mpc85xx.h | 16 +
> arch/powerpc/include/asm/fsl_ddr_sdram.h | 6 +
> arch/powerpc/include/asm/immap_85xx.h | 2 +-
> arch/powerpc/include/asm/processor.h | 2 +
> board/freescale/corenet_ds/corenet_ds.c | 2 +
> board/freescale/corenet_ds/ddr.c | 8 +-
> board/freescale/corenet_ds/law.c | 4 +
> board/freescale/corenet_ds/tlb.c | 4 +
> board/freescale/mpc8572ds/ddr.c | 8 +-
> board/freescale/mpc8610hpcd/mpc8610hpcd.c | 25 +-
> board/freescale/mpc8641hpcn/ddr.c | 5 +
> board/freescale/p1023rds/Makefile | 38 ++
> board/freescale/p1023rds/bcsr.h | 53 +++
> board/freescale/p1023rds/law.c | 35 ++
> board/freescale/p1023rds/p1023rds.c | 162 +++++++
> board/freescale/p1023rds/tlb.c | 118 +++++
> board/freescale/p1_p2_rdb/p1_p2_rdb.c | 47 ++
> board/freescale/p2020ds/ddr.c | 6 +
> board/xes/xpedite550x/ddr.c | 6 +
> boards.cfg | 4 +
> doc/README.fsl-hwconfig | 25 +
> doc/README.p1023rds | 101 ++++
> include/configs/MPC8536DS.h | 3 +-
> include/configs/P1023RDS.h | 562 +++++++++++++++++++++++
> include/configs/P1_P2_RDB.h | 3 +-
> include/configs/P2020DS.h | 3 +-
> include/configs/corenet_ds.h | 39 ++-
> include/ddr_spd.h | 4 +-
> nand_spl/board/freescale/p1023rds/Makefile | 132 ++++++
> nand_spl/board/freescale/p1023rds/nand_boot.c | 99 ++++
> 49 files changed, 1888 insertions(+), 75 deletions(-)
> create mode 100644 arch/powerpc/cpu/mpc85xx/p2040_ids.c
> create mode 100644 board/freescale/p1023rds/Makefile
> create mode 100644 board/freescale/p1023rds/bcsr.h
> create mode 100644 board/freescale/p1023rds/law.c
> create mode 100644 board/freescale/p1023rds/p1023rds.c
> create mode 100644 board/freescale/p1023rds/tlb.c
> create mode 100644 doc/README.p1023rds
> create mode 100644 include/configs/P1023RDS.h
> create mode 100644 nand_spl/board/freescale/p1023rds/Makefile
> create mode 100644 nand_spl/board/freescale/p1023rds/nand_boot.c
Applied, thanks.
Best regards,
Wolfgang Denk
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
We are all agreed that your theory is crazy. The question which
divides us is whether it is crazy enough to have a chance of being
correct. My own feeling is that it is not crazy enough. - Niels Bohr
More information about the U-Boot
mailing list