[U-Boot] [PATCH, AT91, rework v2] change common at91sam9261 files after AT91 rework

[RONETIX - Asen Dimov]

and one forgotten answer ...

On 07/26/2011 12:11 PM, RONETIX - Asen Dimov wrote:
> Hello Reinhard,
>
> On 07/26/2011 10:14 AM, Reinhard Meyer wrote:
>> Dear Asen Dimov,
>>> Signed-off-by: Asen Dimov<dimov at ronetix.at>
>>> ---
>>> Note:
>>> This patch was a part of patches, but it is better to be done step 
>>> by step and
>>> so this patch is a split from the patch series with message id:
>>> <1307606409-29818-2-git-send-email-dimov at ronetix.at>
>>> and Patchwork:
>>> http://patchwork.ozlabs.org/patch/99665/
>>>
>>> Changes for v2:
>>>     - add CONFIG_AT91_GPIO_PIULLUP
>>>     - reneme at91_serial3_hw_init() to at91_seriald_hw_init()
>>>     - remove at91_serial_hw_init()
>> What I miss in at91sam9261_devices.c (as compared to the 9260)
>> is support for MACB and MCI. Don't 9261 systems use Ethernet?
>> Or is that part still in the board specific files?
>>
that part is in the board file.

[snip]
> Regards,
> Asen