[U-Boot] [PATCH] phy.c: make less verbose - turn printf() into debug()

Andy Fleming afleming at freescale.com
Fri Jul 29 23:26:44 CEST 2011


On Jul 27, 2011, at 8:22 AM, Kumar Gala wrote:

> 
> On Jul 25, 2011, at 2:39 AM, Wolfgang Denk wrote:
> 
>> The PHY driver was too verbose and corrupted the boot message display
>> like this:
>> 
>> 	...
>> 	Net:   TSEC0 connected to Marvell 88E1111S
>> 	TSEC1 connected to Marvell 88E1111S
>> 	TSEC0, TSEC1
>> 	...
>> 
>> Turn printf() into debug() so we het the expected output again:
>> 
>> 	...
>> 	Net:   TSEC0, TSEC1
>> 	...


Hmmm.... That output is quite useful. There are a large number of situations where those messages signal to the user that their configuration is a certain way (perhaps not the one they thought).  However, I'm fine with those messages not interfering with the Net: foo... printouts.  Perhaps we could add a separate print in the Net code which iterates through the PHYs and prints out the information?

Andy


More information about the U-Boot mailing list